Models > MGR6875ADS

MGR6875ADS Maytag Range - Overview

Get Parts and Repair Help for MGR6875ADS

If you know the range repair part you need, you can browse the list of all parts on the MGR6875ADS, or you can search by name or part description. You can also find your part by where it is located on the MGR6875ADS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for MGR6875ADS parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.76

Grate Foot

Sold individually.

$2.70

Screw

Sold individually.

$3.76

Levelling Leg

This leg is sold individually.

$28.56

Short Oven Sensor Kit

This temperature sensor detects the temperature within the oven cavity.

$2.70

Screw

This screw is sold individually.

$13.81

Surface Burner Spark Igniter

This part helps your burner ignite and produce flame.

$52.75

Bake Igniter

This part ignites to help bake your food.

$2.70

Screw

This screw is sold individually.

$2.70

Screw with Washer

$51.29

Oven Rack

Used in the lower oven. Sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

F1 code - gas over would not heat.

  • Customer: george from birmingham AL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 72 of 80 people found this instruction helpful
Repair tech checked oven and said the control panel was bad and needed to be replaced. The new control panel would cost over $450.00! I found that the oven sensor was bad and replaced it for $30.00. The old oven sensor had failed following a self cleaning cycle. I found that the wires coming out of it were burnt.

Replacing the oven sensor was ... read more

Ignitor was bad on upper oven

  • Customer: David from Temple Terrace FL
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 28 of 33 people found this instruction helpful
First I removed the lower tray and all parts covering the ignitor on the upper oven. 2. Then I removed the screws holding down the ignitor and flame distributor. 3. I then had to pull out the oven from the wall and remove the back panel to expose the wires connecting the ignitor. This required the removal of about six screws but they were fairly easy to ... read more

Oven Door Inner Glass Broken

  • Customer: Shariq from West Conshohocken PA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 21 of 22 people found this instruction helpful
This is fairly easy for anyone to do. First I opened up the front (silver part) of the oven door by removing the screws at the top and the bottom. Then I kept on removing the various layers of glass... the 2 outside ones are removed by removing their respective screws and then you get to the inner-most. These 2 inner ones are in a frame that holds them t... read more