Models > MGR5775QDS

MGR5775QDS Maytag Range - Overview

Get Parts and Repair Help for MGR5775QDS

If you know the range repair part you need, you can browse the list of all parts on the MGR5775QDS, or you can search by name or part description. You can also find your part by where it is located on the MGR5775QDS by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for MGR5775QDS parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$55.77

Gas Oven Igniter - Vertical Mount

This gas oven igniter is a little over three inches long. It has a white ceramic base and a gray silicon carbide igniter. This igniter assembly comes with its own metallic mounting bracket, and an eight inch long wire lead with a plastic plug.

$3.76

Grate Foot

Sold individually.

$3.76

Levelling Leg

This leg is sold individually.

$2.70

Screw

Sold individually.

$24.90

Short Oven Sensor Kit

This temperature sensor detects the temperature within the oven cavity.

$2.70

Screw

This screw is sold individually.

$53.87

Igniter - Horizontal Mount

This part is used to light the oven for the bake or broil.

$18.07

2 Piece Broiler Pan

$28.95

Door Hinge - Left or Right Side

This door hinge can be used for the left or right side. As per the manufacture if the hinges have never been replaced,on the appliance,they suggest to replace the door hinge receptacle kit.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven wouldn’t heat up properly

  • Customer: James from Berwick ME
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 114 of 126 people found this instruction helpful
My oven has two igniters so I needed to determine which one was the problem.

Using the amp/multi meter I tested the connection between the igniters and the valve, with the oven turned on, to find the bad igniter. Depending on the model of stove you have, the amp reading you need for a properly functioning igniter will vary. My lower igniter read ... read more

F1 code - gas over would not heat.

  • Customer: george from birmingham AL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 62 of 69 people found this instruction helpful
Repair tech checked oven and said the control panel was bad and needed to be replaced. The new control panel would cost over $450.00! I found that the oven sensor was bad and replaced it for $30.00. The old oven sensor had failed following a self cleaning cycle. I found that the wires coming out of it were burnt.

Replacing the oven sensor was ... read more

Our oven would not heat up, smelled like gas.

  • Customer: Theresa from Yorkville IL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 37 of 42 people found this instruction helpful
I removed the oven door, unscrewed a couple of screws, replaced the ignitor, put screws back in, done! Sometimes it would take my oven up to an hour to heat up and sometimes it just wouldn't heat up, just fill the house with a gas smell. Now, it heats up in about 3 minutes!! We were considering buying a new oven, we will just keep this one. $40.00 beats $70... read more