Models > MGC5430ADC

MGC5430ADC Maytag Cooktop - Overview

Get Parts and Repair Help for MGC5430ADC

If you know the cooktop repair part you need, you can browse the list of all parts on the MGC5430ADC, or you can search by name or part description. You can also find your part by where it is located on the MGC5430ADC by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. We’ve also included any installation videos we have for MGC5430ADC parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the MGC5430ADC [Viewing 3 of 3]

$15.25

Top Burner Igniter

This top burner igniter comes with a mounting bracket.

$3.81

Rubber Grommet

Used as the bottom feet of a gas stovetop grate. Sold individually.

$24.70

Burner Head Cap with Spark Electrode

This is a black burner head with the spark electrode. NOTE: This part has been updated and there is no longer a gasket seal required.

$2.70

Screw

This screw is sold individually.

$25.23

Burner with Electrode

$3.82

SCREW

$19.26

Surface Burner Knob

Sold individually. This knob accepts a D-shaped shaft.

$3.71

Igniter Wire

$3.82

SCREW

$51.97

Single Burner Grate

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

gas burner ignitor failure

  • Customer: roy from East Providence RI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 66 of 75 people found this instruction helpful
Lift out sealed burner assembly rear of stove first while careully sliding to rear to disengage ignitor probes.Remove philips head screws from bottom sheet metal housing to expose bottom of burners Remove gas tube assembly screws and move tube away carefully.Unplug wires from ignitor.Remove screws for ignitor .Remove ignitor, I noticed that rust and dirt ha... read more

Burner wouldn't start

  • Customer: Yury from Brooklyn NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 17 of 26 people found this instruction helpful
Make a quarter turn counterclockwise, disengage a burner head, disconnect 2 wires, connect to a new head, install turn clockwise.

That's it! read more

The grommets came apart metal from rubber.

  • Customer: Frank from Pierce ID
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 11 of 14 people found this instruction helpful
I replaced the broken grommets with the new ones. I purchased 8 so I would have back ups because I did not feel the new one would last either. I think they cost TOO MUCH but I could not haggle for price. read more