Models > MFI2568AES Maytag > Instructions

MFI2568AES Maytag Refrigerator - Instructions

All installation instructions for MFI2568AES parts

These instructions have been submitted by other PartSelect customers and can help guide you through the refrigerator repair with useful information like difficulty of repair, length of repair, tools needed, and more.

All Instructions for the MFI2568AES
406-420 of 570
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

I shut the door while tray was open,broke pin on tray

  • Customer: Loren from E Wenatchee WA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 0 of 0 people found this instruction helpful
took screws out put new end cap on put pack screws and was done. just that easy. Thank you

Replaced ice & Water filter, but message on refigerator still shows "Replace Filter"

  • Customer: David from Portland OR
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
As per instructions to replace filter

The door tab broke off

  • Customer: Jeffrey from Kirkland WA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 0 of 0 people found this instruction helpful
pull drawer x2 pull glass shelf pull glass shelf support pull deli drawer cover then drawer pull left drawer guide screws 2 pull glide screws 2 reassemble clean as you reverse process easy

Parts were broken

  • Customer: heby from Whittier CA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Pretty easy, just a screw driver and replacing the parts. We were surprised on how easy it was.

Light switch broken

  • Customer: Keith from Racine WI
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
I used a knife blade to slip under the edge of old switch to pray it out of the hole it was inserted into, switched the wires and replaced the new switch into the same hole. It took about five minutes!

broke the tray door hinge.

  • Customer: richard from margate FL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Socket set
  • 0 of 0 people found this instruction helpful
removed the drawers and shelf. removed end cap with a socket replaced new part, reinstalled drawers and shelf. probably took 7 minutes start to finish.

broken center rail

  • Customer: Elisabeth from Reston VA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
The only challenge is: finding the correct replacement part for this model. Once that is done, the part just slides in, no tools needed.

Broken Pantry Lid Cover Hinge

  • Customer: David from San Jose CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Wrench set
  • 0 of 0 people found this instruction helpful
It was easy, since I took the old one out, I knew what to do to put the new one in. Not problem, just a couple of screws!

Frig & freezer section would not cool/too warm

  • Customer: Alan from Trafalgar IN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Easy to replace part - remove panel at the bottom rear of the appliance, unplug from the compressor and connect the new relay. Unfortunately, it was not the relay on my appliance -- looks like the compressor has gone out -- new fridge for me

Plastic clips broke

  • Customer: Darryl from Santa Fe NM
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
New kick plate snapped right into place. Did not need the grille clips

Light burned out in upper oven

  • Customer: Shirley from Las Vegas NV
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Screwed in light bulb and glass protector

frige warm and freezer icing up

  • Customer: Tricia from Folsom CA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 0 of 0 people found this instruction helpful
I pulled the frige out, took off the cover from the bottom with a nut driver. Took off the safety clip then pulled the plug out from the relay then the relay came out. Replaced the part and reinstalled the same way. This was really easy and fast.

brokenpivot arm

  • Customer: Will from Missoula MT
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 0 of 0 people found this instruction helpful
used the directions from PartSelect

broken viewer

  • Customer: Acte from New York NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
simply repalced

Ice and Water Filter needed to be replaced.

  • Customer: Louis from Covington KY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
I snapped the cover plate to the filter open. Pulled the filter down and twisted counter clock wise to take filter out. I installed the new filter in by inserting the filter and tuning clock wise to secure the filter. I flushed the water for about two minutes and then allowed it to be put back into service.
All Instructions for the MFI2568AES
406-420 of 570