MFI2568AEB Maytag Refrigerator - Instructions

Unplugged appliance. Using a small putty knife I moved the switch out far enough to grab it with pliers. Moved wiring to new switch and pushed into place after testing.

I took out the glass shelf that sits above the deli drawer. I removed the two veggie drawers. Unscrewed the two sides and pulled them out. The left side went right back in with the new part. The right side gave me concerns as it had the control slide. It came out easily. I had to R/R both roller slides with no problem. I took out the control slider parts and readily reinstalled them on the new piece. Reinstall of completed assembly went in without a hitch. It took very little time, I had the correct parts, screw holes were right on. Perfect fit, perfect part! It's as easy as that!!!

Took off the only screw holding the drawers in place and removed old left and right end caps. Replaced with new parts and additional screws; then put on the cover so the drawer actually works again. Really easy job.

I took out the drawers, cleaned off the shelf above then took the glass shelf out of the fridge. The broken piece just lifted out and I snapped the new one in and replaced everything! All better!

So easy my wife did it!!!!!

After reading others who did this same repair, I removed the bins and emptied the bottom shelf. Now came the hard part as the glass had not been removed in a long while. It was stuck on with gunk. I removed the top glass and the lower glass by putting hand pressure from underneath and cleaned them. This took the longest time. With the bottom glass in and the top glass out, I snapped in the new piece, the actual repair took about 5 minutes including putting the drawers back in and testing them.

I put a stainless steel screw into the pantry end cap to hold the shelf trim in place so my pantry drawer would operate.

I removed the cover panel. There is a clip that holds the relay and capacitor to the pump. Use a screwdriver to pry it off. Unplug the relay. The capacitor is plugged into the relay and they come together which was a surprise, I thought I only ordered the relay. Unplug a cable from the relay. Insert that cable into the new relay and plug it into the compressor. Reattach the clip. One be important instruction. Unplug the refrigerator for at least 8 hours before installation to allow the compressor to cool down. I tried first without allowing the compressor to cool and it did not work. After letting it cool I tried again and it worked like charm. Make sure the refrigerator is unplugged when doing the repair

Remove the shelves and the other trays. Use the nutdriver to extract the screws and the panel. Pay attention to the orientation of plastic parts when replacing plastic slides to avoid breaking the plastic slide components. Avoiding too much stress on plastic parts is important.

Remove the pantry drawer door, then remove the pantry drawer. Remove the 2 vegetable bins to gain rom to see and to ease access. Remove the 2 screws holding the end cap to the interior of the box. remove the slide from the end cap and place it on the new one. Reinstall the end cap being sure to have the tabs go into the slots at the back. Make sure the end cap also mates with the tab in the front, Reinstall the drawer and the bins and the pantry door.

I removed all drawers (including the two above the repair site, removed the left side end cap - it was help in place with only two screws (one screw hole appears never to have had a screw). Swapped out the broken part for the new one, reinstalled the screws, put the drawers back, mounted the operable door to the two hinge pins, and things were fixed.

Ordered parts on Tuesday. They arrived on Thursday and I completed the protect SAP.No Problem at all.I used hints from others,removed the 3 screws with my nut driver and completed the job as a pro.My Bride(of 63 years) was amazed at my ability Thank you Part Select.I informed all of my Family members of your prompt service

I removed salad and veg draws, pantry draw and the two glass shelves. Located and removed the screws holding the pantry side, gently eased the side out and replaced with the new one. Just a breeze to replace and for a 73 old female, pretty good. Thank you PartSelect for speedy delivery of part.

Unscrewed old water filter. Screwed in new filtr. Moved lense off track. unscrewed bulb. Screwed bulb. Slid lense back in.

Removed both drawers and glass shelf just above the drawers. Center rail just fit into place. Replaced glass shelf and both drawers. Took no more than 5 minutes.