Quick Question!

Have you ever purchased from PartSelect.com before?

Models > MEW6530AAW

MEW6530AAW Maytag Wall Oven - Overview

Get Parts and Repair Help for MEW6530AAW

If you know the wall oven repair part you need, you can browse the list of all parts on the MEW6530AAW, or you can search by name or part description. You can also find your part by where it is located on the MEW6530AAW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your wall oven. We’ve also included any installation videos we have for MEW6530AAW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.91

Light Bulb - 40W

Sold individually.

$29.46

Long Oven Sensor

This oven sensor kit comes with two harness adapters. This sensor detects the temperature within the oven cavity.

$66.33

Inner Door Glass Pane

Glass only.

$5.15

Insulation

This strip of insulation is located within the oven door.

$59.02

Door Glass with Tape

$4.47

Screw

This screw is sold individually.

$156.53

+ FAN- AS

Rubber Door Spacer

Sold Individually. This spacer has adhesive on one side. This spacer is used between door panels of ranges and ovens.

TAPE, FOIL (8.75" X 1") (Qty 2) (Series 10)

$8.10

SPRING- DO

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven not holding 350 F, when cooling the coils did not reheat

  • Customer: David from Westford, MA
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 105 of 121 people found this instruction helpful
Removed the oven door by opening slightly, then pic door up to remove. Remove 2 screws holding oven sensor in place, gently pull on sensor to remove, had to remove about 8 inches to get at plastic connector. Unplug connector, had to use an adapter cable supplied with the PartSelect kit to install new sensor, push cable back into opening, reinstall 2 screws. ... read more

F1-1 code

  • Customer: charles from marstons mills, MA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 45 of 56 people found this instruction helpful
First I removed the two screws that hold the element in place. I then pulled the sensor out about 3 inches and disconnected the two wires. Next, I connected new sensor and screwed the new sensor back in place. One area for caution. Make sure that the electrical connection is pushed in past the insulation on the back side of the oven. Failure to do so will ... read more

Needed to replace oven door gasket.

  • Customer: Lori from Scottsdale, AZ
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 41 of 50 people found this instruction helpful
First removed the old gasket using a needle-nose pliers. Then placed new gasket by inserting the little clips on the gasket. Took 5 minutes. Great instructions from Repair Forum. read more