Quick Question!

Have you ever purchased from PartSelect.com before?

Models > MERH752BAB

MERH752BAB Maytag Range - Overview

Get Parts and Repair Help for MERH752BAB

If you know the range repair part you need, you can browse the list of all parts on the MERH752BAB, or you can search by name or part description. You can also find your part by where it is located on the MERH752BAB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for MERH752BAB parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.91

Light Bulb - 40W

Sold individually.

$29.46

Long Oven Sensor

This oven sensor kit comes with two harness adapters. This sensor detects the temperature within the oven cavity.

$7.60

Levelling Leg

This levelling leg is just under three inches long. It is all black in color and is made entirely of plastic.

$5.15

Screw

This screw is sold individually.

$34.95

Infinite Switch for Eight Inch Range Burner

This infinite switch for eight inch range burners is almost three inches long.

$47.12

Door Gasket

This oven door gasket comes with built in retaining clips.

$49.08

Bake Element

This bake element is found on the bottom of the oven.

$46.98

Oven Rack

Used in the lower oven. Sold individually.

$45.68

Broil Element

This broil element is found on the roof of the oven.

$5.15

Handle Mounting Screw

This screw is sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Right rear burner went bad

  • Customer: Mark from Loxahatchee, FL
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 106 of 114 people found this instruction helpful
Turned the breaker off, I removed 2 screws securing the range top to the range, opened the top and secured it in the up position, Removed the 2 screws securing the element ,one at a time I swapped the quick connectors from the old element to the new and repeated the process in reverse. I save over $100.00 in labor, plus most companies get you for a trip char... read more

Oven not holding 350 F, when cooling the coils did not reheat

  • Customer: David from Westford, MA
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 110 of 127 people found this instruction helpful
Removed the oven door by opening slightly, then pic door up to remove. Remove 2 screws holding oven sensor in place, gently pull on sensor to remove, had to remove about 8 inches to get at plastic connector. Unplug connector, had to use an adapter cable supplied with the PartSelect kit to install new sensor, push cable back into opening, reinstall 2 screws. ... read more

The Burner was getting too hot and you could not regular the tempature

  • Customer: Dennis from Hagerstown, MD
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 47 of 53 people found this instruction helpful
Moved the Appliance out unplugged it and removed the backing plate then Remove the Knob and unscrew the infinite switch then marking the 5 wires to know where the go on the new switch, removing and replaced it with the new one read more