MER5770AAW Maytag Range - Instructions

I removed the broken hinge and installed the new one, however the oven door didn't stay ajar but dropped open fast. So I took the old spring and installed it on the new hinge and it was improved. It just took a screwdriver.

I removed the old thermostat and replaced it with the new one using the supplied wiring adapter for my model of range. Parts Select made this an easy project. Thanksyou

unplugged the oven from the 220 volt receptacle. Removed the wire shelves. Unscrewed the two screws holding element to rear of oven. (I didn't know at this point to pull the wires through from the back so I took the back panel of the oven off and unplugged the connectors from the rear). Measured the defective element, ordered, and two days later I reversed the process when the package arrived in the mail. . quite simple. I love it when I can fix something myself. And by fixing, I actually mean "replacing".

Followed directions as supplied. New part did not work, so it must be in the control unit which is no longer available. So time for a new range.

followed you tube instructions. Very helpful feature. thanks

Remove both oven racks. Remove the screw that is on each side of the element holding it in. Pull the element out and disconnect the wire on each side of the element.Remove the bad element and replace it with the new element. Connect the wires to the new element and gently push the element back into place. Put the screws back into place and tighten. Replace the oven racks into oven. Turn oven onand verify that the element is heating. Repair is comlete.

Remove sensor from oven. Disconnected wire from back. Connected new sensor and reinstalled. Temps now stay stable.

Watched the video and it was as easy as described. Not many things go as easily as this.

I watched the video, which was very helpful...the temperature sensor was hard to pull through the small opening in the upper back left oven corner. On the back wall of the oven was a large removable circle, so I unscrewed that piece and was able to gain access to the wires attached to the temperature sensor and push it through the small opening. I used one of the new connectors, pushed it back through the small opening, screwed it back onto the oven wall, replaced the circle opening and tried the oven again...unfortunately, there was no improvement in oven temperature! My JennAir wall oven is about 17 years old, and I thought I would try this $30 repair prior to purchasing a new wall oven, but it looks like I will have to do some overtime and buy a new oven. Any other suggestions would be welcome.

Followed video

After we got the part in the mail my husband put it on and shortened the wires and put new plugs on the ends of the wires and we had to get a new plug put it on and it was fixed.

I first pulled out stove, then disconned the power supply. Then removed rear panel which exposed connections to the bake element which was shorted out against one side of the rear panel. Replaced the bake element, then the rear panel followed by pugging in the stove and pushing it back into place then opened the oven door and tested the element to see that it was working properly. Thank you Partselect for your fast service on getting the part that I needed quicky and at a fair price.

I think the installation instructions are fairly self explanatory. This is the second item I've ordered from Parts Select and I'm thrilled with their service. The items are always less expensive than other sites and they deliver what they promise. I would highly recommend them.

Turned off Power to oven, flipped breaker. Unscrewed two screws, removed old burner, inserted new burner, screwed in. Turned breaker back on.

Unscrewed three screws securing the glass top. Lifted glass top and wedged it open. Took a picture of the current wiring. Removed old burner.Compared male contact points on new and old burner. Plugged new burner in appropriately. Note: The new burner is MUCH hotter than the old one.