Models > MDU300CB

MDU300CB (P1188304W) Amana Dishwasher - Overview

Get Parts and Repair Help for MDU300CB

If you know the dishwasher repair part you need, you can browse the list of all parts on the MDU300CB, or you can search by name or part description. You can also find your part by where it is located on the MDU300CB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.70

Screw

This screw is sold individually.

$3.83

SCREW

$6.52

Door Handle Mounting Screw Kit

$26.84

Cable & Eyelet

This part helps hold the door in place.

$4.36

CLAMP

$2.70

Screw - 6-32 x 5/16

$2.70

Ground Screw

$47.27

SPRAY ARM

WHEEL

$3.83

Screw

Common Symptoms of the MDU300CB [Viewing 1 of 14]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

WOULDN"T DRAIN THE WATER COMPLETEY

  • Customer: clarence from ST LOUIS MO
  • Difficulty: Really easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers
  • 2 of 3 people found this instruction helpful
removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires...) read more

Spring that holds door closed

  • Customer: Bessie from Fruitland Park FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 4 of 10 people found this instruction helpful
First, removed screws on bottom panel. On this model, everything was easy to see. Did not have to move the appliance at all. The left side wire was broken. Just removed the broken part, connected the new wire, and then the springs to it. No problem at all. Took about 15 mins. read more

Two upper rack rollers were broken

  • Customer: Duane from Seattle WA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 1 of 2 people found this instruction helpful
Used ascrewdriver to bend the metal rail that the roller rolls on. The part that needed to be bent holds the end cap on. Once bent, the end cap pops off. The the old roller can be removed and the new roller instsalled. The rail then needs to be re-bent. read more