Models > MDH25YF1

MDH25YF1 Frigidaire Dehumidifier - Overview

Get Parts and Repair Help for MDH25YF1

If you know the dehumidifier repair part you need, you can browse the list of all parts on the MDH25YF1, or you can search by name or part description. You can also find your part by where it is located on the MDH25YF1 by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Water Container Reservoir and Float

$27.55

Compressor Start Relay

$29.18

Float

$84.07

Humidistat Control

This control needs to be replaced if the dehumidifier won't shut off.

$0.74

LENS

KNOB-CONTROL

$23.68

Auto Shut Off Switch

Fan Motor

$2.56

SCREW

$87.71

THERMOSTAT DEFROST

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

fan motor had froze up (not turning)

  • Customer: James from Floyds Knobs IN
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Screw drivers, Socket set, Wrench(Adjustable)
  • 4 of 7 people found this instruction helpful
Took unit outside
removed the covers
cleaned dust and lint out with high pressure air
removed motor and tryed to repair it
when this didnt work I took it in to my desk and ordered a new motor on-line, this was at 2:30
the next day at 10;30 the new motor arrived via UPS. I installed it and the unit has run fine ever since. read more

Unit would run continuously and not shut off

  • Customer: Jonathan from New Oxford PA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 3 of 4 people found this instruction helpful
Removed the front cover and then the humidistat from the bracket. Two push on wire connectors and then reversed. Very straightforward and excellent part matching. Given the prices for new dehumidifiers it was great to breathe life back into this unit which does its job well. Thanks for the easy to use web site and fast fast service! read more

Compressor was short cycling

  • Customer: Sherman from Tuttle OK
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 4 of 8 people found this instruction helpful
Removed the cowling with a square drive screw driver, removed the spring clip from the cover of the compressor controls with a screw driver, pulled off the old compressor start relay and replaced it with the new part. Since other problems could have caused the compressor to short cycle this was a "replace the part and hope it would work" since that would be ... read more