Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
Below is a list of all parts for the Maytag Dryer MDG5500AWW - Residential. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.
This drum support roller includes one drum roller and two bearings. Most dryers use two drum rollers, and is recommended to change both at once.
This gas dryer ignition coil set comes with two ignition coils: one three terminal Boost/Hold coil, and one two terminal secondary coil. Usually only one of them burns out but you should replace them as a set. Both have to be operational for the gas valve to open.
This front glide kit comes with a blue plastic glide, a brown cork pad, and two metallic rivets. Two kits are required per appliance. Also, a rivet tool is required for this kit -...
This roller shaft acts as the axel for the drum roller. Also known as drum roller axle.
At 91-5/8 inches in length, this dryer drum belt from Maytag has five ridges. It is all black in color and is made entirely of rubber. This flat belt is 3/8 of an inch wide.
This idler pulley wheel is white and made of plastic. It is two inches in diameter and comes with a center bearing.
This is a rectangle shaped lint filter screen used for some gas and electric clothes dryers. The dimensions of this lint filter screen are approximately twelve and a half inches lo...
This metallic retaining ring is less than an inch in diameter. It is made entirely of metal.
This part senses the flame for heat allowing the gas valve to open.This flame sensor is three inches long and is used for many gas clothes dryers.This flame sensor assembly is made...
This roller shaft washer is just under an inch in diameter and is used for some of Whirlpool's brands of clothes dryers.Sold individually.
This seal can be used for the front or rear drum. Adhesive is NOT included.
This flat style igniter comes with a wire harness connector. This part ignites the gas within the dryer. Bracket is NOT included.
This idler pulley shaft washer is used with many clothes dryers. It is less than an inch long, and it is black in color.
This part moves the clothes around inside your dryer and helps to direct the flow of hot air during the drying cycle.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.