Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
Below is a list of all parts for the Maytag Dryer MDE9206AYW - Residential, Electric. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.
This door catch kit is designed for use in dryers. This is an authentic OEM replacement part. This catch assembly ensures the door of your appliance will close, and remain closed. ...
This high limit/safety thermostat is used on many of Maytag's brands of gas and electric clothes dryers. With this thermostat, a dryer's heating element will cut out if the internal temperature reaches 200 degrees Fahrenheit. The element will kick back in when the temperature drops to 170 degrees Fahrenheit.
This screw is sold individually.
This arm is what attaches to the idler pulley wheel.
This roller shaft hex nut measures well under an inch long. It is made of metal and is used for Maytag brand clothes dryers.
This timer knob is not quite three inches in diameter. It is all gray in color and it is made entirely of plastic.
This timer knob insert cap is just over two inches in diameter. It is all white in color and is made of plastic.
This gray levelling leg foot pad is made of rubber and is just over an inch in diameter.
This sleeve is less than an inch in diameter. It is made of metal and is intended for use with the screw that holds the idler pulley of your clothes dryer.
This blower wheel clamp, used in a clothes dryer, is a clamp that holds the blower wheel to the motor shaft. This part helps hold the blower wheel in place to function easily and properly. If your clothes dryer has any of the following symptoms then replacing the clamp can be a solution: making loud noises, not producing enough heat or no heat at all, and/or clothes are taking too long to dry. Make sure to unplug thedryer from power source before installing this part and refer to the installation instructions provided by the manufacturer for further guidance.
This idler shaft retaining ring is well under an inch long and is made of metal.
This thermal fuse is mounted on either the heating element or burner tube housing.
This part has a D-shaped motor shaft and this motor runs at 1/4 horsepower and carries 4.5 amps.
This blower wheel does not come with a spring clamp, but it does have twenty fins and it is designed to fit a 3/8 of an inch motor shaft.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.