Quick Question!

Have you ever purchased from PartSelect.com before?

Models > MDE6400AYW > Parts

MDE6400AYW Maytag Dryer - Parts

All parts for the Maytag Dryer MDE6400AYW

Below is a list of all parts for the Maytag Dryer MDE6400AYW - Residential. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the MDE6400AYW
15-28 of 139
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$16.71

Door Switch Kit

This part replaces two terminal switches in a dryer and prevents the dryer from running when the door is open. This includes two connectors. If your dryer will not shut off, start,...

$14.78

Door Catch Kit

This door catch kit is designed for use in dryers. This is an authentic OEM replacement part. This catch assembly ensures the door of your appliance will close, and remain closed. It allows your appliance to both start and complete a full drying cycle. There are two pieces included in this kit, one catch, and one strike. You open and close the door on such a regular basis that this mechanism can wear out. It is a fairly common part to replace. You will need to remove the door of your dryer to install the replacement catch assembly.

$17.36

Idler Arm and Shaft

This arm is what attaches to the idler pulley wheel. The grommet no longer comes with the part as it has been updated by the manufacturer.

$4.07

Screw

This screw is sold individually.

$4.02

Rubber Leveling Leg Foot Pad

This gray levelling leg foot pad is made of rubber and is just over an inch in diameter.

$5.81

Idler Arm Screw Sleeve

This sleeve is less than an inch in diameter. It is made of metal and is intended for use with the screw that holds the idler pulley of your clothes dryer.

$4.94

Roller Shaft Hex Nut

This roller shaft hex nut measures well under an inch long. It is made of metal and is used for Maytag brand clothes dryers.

$5.81

Blower Wheel Clamp

This blower wheel clamp, used in a clothes dryer, is a clamp that holds the blower wheel to the motor shaft. This part helps hold the blower wheel in place to function easily and properly. If your clothes dryer has any of the following symptoms then replacing the clamp can be a solution: making loud noises, not producing enough heat or no heat at all, and/or clothes are taking too long to dry. Make sure to unplug thedryer from power source before installing this part and refer to the installation instructions provided by the manufacturer for further guidance.

$5.98

RING-E

This idler shaft retaining ring is well under an inch long and is made of metal.

$23.55

Blower Wheel

This blower wheel does not come with a spring clamp, but it does have twenty fins and it is designed to fit a 3/8 of an inch motor shaft.

$22.41

Thermal Fuse

This thermal fuse is mounted on either the heating element or burner tube housing.

$139.44

Drive Motor - 115V

This part has a D-shaped motor shaft and this motor runs at 1/4 horsepower and carries 4.5 amps.

$3.57

Idler Spring with Rubber Dampener

$3.02

Screw

Sold Individually.

All Parts for the MDE6400AYW
15-28 of 139