This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch...
$20.79
In Stock
Order within the next 10 mins and your part ships today!
They are all strung with a coiled wire made of a nickel and a chrome alloy. This wire receives, but resists, a controlled electric current and as a result, the wire heats up. The heat produced is used...
This part is the replacement drum support bushing for your dryer. It is made of white plastic and measures approximately 1-3/4 inches by 1/2 inch. The drum support bushing is the part that supports th...
$64.25
In Stock
Order within the next 10 mins and your part ships today!
Order within the next 10 mins and your part ships today!
Questions And Answers for MDE2400AZW
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
1 question answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Wayne
February 14, 2024
how to remove the front panel and control board ???
For model number MDE2400AZW
Hi Wayne,
Thank you for your question. Here is a link to one of our YouTube videos that you may reference for information on how to remove both the control panel and the front panel. The dryer in the video may not be the same as yours, but it will give you a general idea on how to remove the parts. We hope this helps!
Don't pay a repair service for this job when you can do it yourself. Pop the two panels off the back of the machine. The top one is where you'll unhook the old heating element. The bottom one (where the exhaust is) is where you'll need to unhook the broken heating element from it's connector. Place the new heating element's wires down thr
... Read moreough the back of the machine, plug the wires in (note - this is a 3-prong plug and it should only fit one way - the correct way) to the connector, and re-assemble.
Note: make sure that the exhaust pipe is secured back in its base. Getting the bottom panel back on is a little tricky, but you'll get in after a couple tries!
replaced plastic bushing at rear of unit. all you have to do is have acess to the rear of the dryer, no need to open dryer from front or top. squeeking noise stop but wonder how long the plastic part will last!!!! can not beleive that maytag installed such a low quality bushing. no appliance servicemen want to repair unit when noise first
... Read more occurred. i replaced the $10 part with help moving the stacked unit down from washer. saved $150 service call.
I tried to find this thermostat from shops in the town I live, but I could not. So I ordered it from Partselect. The website is very easy to find this kind of thermostat. I can compare my burned thermostat with the picture in the website. Also it send to me on time. I just plug it in the socket behind the dryer. I took only few minutes to
... Read more repair.
.gif "SUPPLEMENTAL INFORMATION Diagram and Parts List for Maytag Dryer")
