MDE10DAAEL Maytag Dryer - Instructions

I basically just followed the excellent instructions in the PartSelect video; I highly recommend it. Be careful of other sites, I had one site that told me to take off the top of the dryer somehow, which would have been MUCH harder. Be sure to lay down a drop cloth, it is dirty inside these things.

Followed the video to the tee really easy. But I have been in the dryer before teflon rub guides and belt.Take the front off, then the drum bracket four screws, open the blower wheel cover, remove the locking clip the wheel just slid off then, put it back together everything lined up just fine. then say to your wife listen to the dryer you can't hear! Works great.

removed front cover and rear access panel took belt off tensioner removed front drum support removed drum replaced two rollers by removing snap rings and put it back together in reverse... The maytag repair man is still lonely

The online video was the extremely helpful in aiding me in the repair. Thank you so much for posting it. Couldn't have done it without it.

Installing the Front Glide Kits was straight forward if you watch the video. The guides resolved a part of my problem, but I discovered the Blower Wheel was cracked and out of round. replaced it and poof its fixed!

Simply dropped it in. I have never had a simpler installation! Service was a+!

noticed that male half was in good working order, so I just snapped in the new female half; without any tools. easy repair!

Followed the guidance on video.

I purchased the drum belt locally then searched the internet for an instructional video and found it on your website. Once I got into the dryer which is 24 years old, I discovered many other parts that needed to be replaced. So at that time I ordered all other items from PartsSelect.com. Before each repair, I started with the instructional video. First repair was the front glide kit, followed by the front and rear drum felt seals. Next, I replaced the drum support rollers and the idler pulley wheel. Last, I replaced the blower seal then put it all back together and installed the drum belt last. Also, while everything is apart it’s a good time to vacuum up all the lent in the dryer. I placed the dryer back into the laundry room and immediately started using it. We’ve probably already run 20 or more loads through the dryer and its working great. I’m hoping to get many more years of service out of it. Thanks Parts Select….I could not have wished for a better repair experience. You now have a loyal customer.

found info describing the nocking noise found parts to fix it watched video on how to do the repair The step by step instructions made the job so easy We saved over 150.00 in doing the job ourselves. thank you I am amazed at how simple this turned ou to be.

Following video instructions, replaced the belt. Did it once before so this time it was easier. Two years ago I replaced the plastic fan as it was spinning on moter shaft making a loud noise. (The moulded plastic fan has a flat which slides on the motor shaft. The motor start up torque over time (15 + years)stripped the flat allowing the fan to spin on assembly.) The mistake I made was not replacing the belt when I had the machine apart to replace the fan.

Replaced the Blower Wheel, the Idler Pulley Wheel, the belt and blower seal. Cleaned inside of the unit while I had it apart. Runs very quite. Very easy to do repairs.

Opened box with knife and removed filter from sealed package. Inserted filter into filter slot just inside the dryer door. I'm very pleased this filter fits so precisely because the dryer is so old.

son in law..Video was great help...

I followed the instructions