Quick Question!

Have you ever purchased from PartSelect.com before?

Models > MDB9100AWA

MDB9100AWA Maytag Dishwasher - Overview

Get Parts and Repair Help for MDB9100AWA

If you know the dishwasher repair part you need, you can browse the list of all parts on the MDB9100AWA, or you can search by name or part description. You can also find your part by where it is located on the MDB9100AWA by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for MDB9100AWA parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the MDB9100AWA

[Viewing 2 of 2]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$5.44

Door Spring Linkage

The door spring retainer is used in dishwashers. It attaches and holds the door spring to the support frame. If your dishwashers door keeps crashing, or both the door and dish rack...

$17.22

Inner Door Foam Insulation Strip

This genuine inner door foam insulation strip, sometimes known as bottom seal foam, is used to create a waterproof seal that helps prevent leaking from the door area of the dishwasher. The existing insulation strip may leave a sticky residue or leftover disintegrated strip that must be scraped off before installing the new strip. Residue can be scraped off with a putty knife. Be sure to remove all residue and clean surrounding areas of the dishwasher build. It is strongly recommended to check other sealant parts on the dishwasher door such as the door gasket and dispenser grommet to ensure the leaking issue is fully solved.

$4.79

Screw

This screw is sold individually.

$4.12

Door Spring

$18.59

Door Switch

This dishwasher door switch will shut your dishwasher off when the door is opened.

$3.02

Screw

$2.96

Screw with Washer

Sold individually.

$19.90

Switch Holder

$4.89

TIE-WIRE

$316.16

Control, Electric

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

dishwasher door leaks

  • Customer: jerry from vernon, CT
  • Difficulty: Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Screw drivers
  • 73 of 81 people found this instruction helpful
I ordered and replaced both the door gasket (easy) and inner door seal (difficult) to try and correct a leak during operation. The door gasket was easily replaced. However, the inner door seal was a bit more trouble. After removing the inner door I found that the old inner seal needed to be removed and surfaces thoroughly cleaned of old build-up of dishwas... read more

Door switches were worn. Diswasher would not operate unless extreme pressure was applied to the door.

  • Customer: James from Rochester, NY
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 35 of 46 people found this instruction helpful
I pulled the interior of the door until I was able to get to the switches on the door latch. I determined at least one switch was completely worn while the other worked minimally. I then looked for the latch assembly and found out that it was no longer available. So I did some searching and found the exact switches I needed from PartSelect. The switches came... read more

Leaking at bottom of door

  • Customer: E L from Seeley Lake, MT
  • Difficulty: Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 24 of 25 people found this instruction helpful
The initial repair was more involved due to figuring out how to get at the problem. A foam sealer strip located at the bottom of the inner door had lost it's seal. I first sent off for one and it was of relatively thin material. It was carefully installed but still leaked. I ordered another one from Part Select and it had thicker foam. It was installed right... read more