Models > MDB8600AWW

MDB8600AWW Maytag Dishwasher - Overview

Get Parts and Repair Help for MDB8600AWW

If you know the dishwasher repair part you need, you can browse the list of all parts on the MDB8600AWW, or you can search by name or part description. You can also find your part by where it is located on the MDB8600AWW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for MDB8600AWW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$26.31

Door Handle and Latch Assembly with Switches

This part includes the white handle, door latch and 2 switches. This part is a simple on/off mechanism that prohibits the dishwasher from operating when the door is open.

$3.71

Lower Wheel Assembly

Sold individually.

$3.61

Fold Away Tine Pivot

$46.93

Water Inlet Valve

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

$40.39

Rack Adjuster with Wheels - Left Side

This adjuster connects to the left side of the top dishrack. It is used to change the height of the upper rack.

$40.23

Rack Adjuster with Wheels- Right Side

This adjuster connects to the right hand side of the top dishrack. It is used to change the height of the upper rack.

$22.09

Inner Door Foam Insulation Strip

Helps prevent leaking from the door area.

$24.39

Silverware Basket - Split/Fit

This is now one complete basket instead of being sold in 2 halves.

$3.81

Tine Pivot

Sold individually.

$23.31

Docking Station with Flappers

The docking station is located on the water supply tube at the far back. It provides water to the upper and middle spray arm and also includes the flappers.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Broken latch handle

  • Customer: Walter from Tucson AZ
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 493 of 493 people found this instruction helpful
The hardest thing was figuring out that you only need to purchase the latch handle because it only comes as a complete latch assembly, why they even list the latch assembly as a separate part in the parts list stupid. (you get the handle and latch already put together and it cost less than the latch assembly without the handle). Anyway all you need to do is ... read more

Door release latch handle was broken. The handle was deeply recessed into the door and the door was difficult to open.

  • Customer: Dave from Livonia MI
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 467 of 465 people found this instruction helpful
Remove the 8 or 9 torx screws holding the inner and outer door assembly together (leave the bottom screws in), lift the old handle assembly out, transfer the switches to the new handle assembly, and reassemble door. read more

door would not open

  • Customer: jeff from strongsville OH
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 374 of 375 people found this instruction helpful
remove torq scew from edge of inside of door and seperate plastic inner panel from out steel and then pull up on plastci unscrew 2 screw securing handle and reverse to assemble. Anyone can door this in under 10 mins. read more