Quick Question!

Have you ever purchased from PartSelect.com before?

Models > MDB7600AWS > Instructions

MDB7600AWS Maytag Dishwasher - Instructions

All installation instructions for MDB7600AWS parts

These instructions have been submitted by other PartSelect customers and can help guide you through the dishwasher repair with useful information like difficulty of repair, length of repair, tools needed, and more.

All Instructions for the MDB7600AWS
886-900 of 1,099
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Dishes and glasses were left with little specks of food on them.

  • Customer: Vaughn from Great Falls, VA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
We watched the very excellent video on this web site for replacing the Accumulator Filter and followed the instructions it provided. It's possible that we could have just cleaned our existing accumulator filter once we understood what it was and how to get to it, but the results of replacing it have been dramatic. It's like a new dishwasher.

Food chopper was broken.

  • Customer: Bob from Souderton, PA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Wrench set
  • 0 of 0 people found this instruction helpful
Followed video. Everything went together fine, but leaked water around motor shaft seal. Read comments section on video and someone had the same problem. I had pushed the seal into base too deep. I pulled it out and reseated it. It worked without leaking after that. Bob

Cracked drain hose

  • Customer: Jack from Miami, FL
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 0 of 0 people found this instruction helpful
Slid washer out from cabinet after disconnecting drain hose from garbage disposal and unplugging from electrical outlet. Was necessary to lay washer on side to disconnect drain hose from the dishwasher. Have towels ready as you will likely have some leftover water in hose & dishwasher. Used tape to secure insulation pad to washer so it would not catch on the side and top of cabinet when sliding back in place. Easy fix.

Mice living behind the dishwasher

  • Customer: julie from golden, CO
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Mice were living behind and on top of the dishwasher and destroyed the pad. Had to throw it away. Ordering you was easy, and the pad fit perfectly.

Bottom rack needed wheels and tines. Upper rack needed avail stop

  • Customer: Ellena from Madera, CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Easily, just pushed the stop in pushed the wheels on....popped the tine and their holders in. We just purchased this house and the dishwasher needed the parts, But the amazing thing was......the parts were here in less than a day....... NOW THAT IS SERVICE!!

Door latch handle failed

  • Customer: Roberto from Cedar Falls, IA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Install complete latch and handle assembly. Remove panel, disconnect wiring and install the assembly

Door would not close

  • Customer: Micheal from Batavia, IL
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Wrench set
  • 0 of 0 people found this instruction helpful
Removed the panels and the part came right out. Easier than I thought. part came faster then expected.

dishwasher door not closing correctly and bad microswitch

  • Customer: Wesley from Glendale, AZ
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Unscrewed 10 torx fasteners.Pulled inner door panel up to gain access to latch. Latch has both micro switches attached. Un plug switches, remove and replace door latch, button up and your done.

1- dishwasher not cleaning good. 2- dishwasher continued to run after door being open

  • Customer: Carlos from Lancaster, CA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers, Socket set
  • 0 of 0 people found this instruction helpful
1- replaced accumulator filter and docking station with flappers, the docking station with flappers may not have been necessary? But what the heck, if your into it this far why not. Check out the tech. Video it was helpful. The dishwasher works like new now. 2- the door latch switch was worn out, to replace this part I first unplugged the power cord then removed the 8 screws from the inner panel of the door exposing the door latch assembly. Unplugged the two connectors and installed the new part and reassembled everything, pretty easy! The dishwasher works like new now, and for around $ 102.00 bucks, saved lots of money doing it myself, thank you Parts Select for your help. Carlos, Lancaster, California.

Handle broke, difficult to open door

  • Customer: Herbert from Round Rock, TX
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Watched a brief video online at PartSelect site. Video was easy to follow and there were no surprises as I followed the instructions.. I highly recommend the PartSelect company. Herb Wise

door wasn't latching and started its cycle before door was shut

  • Customer: Randall V from Loveland, OH
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
I just followed another persons directions that was in the system already. He had a great idea by taking the new switches out of the new latch and replacing them with the old ones from the bad latch. The old switches are still good and it made for a simple repair. This way you didn't have to disconnect the wire from the switches and now you have two new switches on hand. The old switch had a burnt spot on the connector.

The dishwasher door latch was broken and would not hold the door closed.

  • Customer: Ruth from Canyon Lake, CA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 0 of 0 people found this instruction helpful
I unplugged the dishwasher under the sink. I opened the dishwasher up and took out the 12 screws holding the inside door facing on. I gently moved the door facing down towards the dishwasher to reveal the door locking mechanism at the top of the door. I unplugged the mechanism and plugged in the new one. I put the door back together the same way I had taken it apart. In all it took about 12 minutes. Works like a charm.

Part worn out, needed to replace

  • Customer: Ronald from Tulsa, OK
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers
  • 0 of 0 people found this instruction helpful
No repair, just an replacement. Would recommend this company for good service.

old broken silverware basket

  • Customer: Vincent from Laurel Springs, NJ
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
I put the new one in and that was all

bottom of basket was broken

  • Customer: donald from arnold, CA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
replaced basket with a new one, so easy even a cave man could do it.....i think.......
All Instructions for the MDB7600AWS
886-900 of 1,099