Quick Question!

Have you ever purchased from PartSelect.com before?

Models > MDB6800AWW

MDB6800AWW Maytag Dishwasher - Overview

Get Parts and Repair Help for MDB6800AWW

If you know the dishwasher repair part you need, you can browse the list of all parts on the MDB6800AWW, or you can search by name or part description. You can also find your part by where it is located on the MDB6800AWW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for MDB6800AWW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$34.02

Door Switches and Holder Assembly

This part senses when the door is closed so the cycle can start.

$185.82

Upper Dishrack with Wheels

This rack comes complete with four attached wheels and the rack may differ in appearance, but will function same as original part.

$24.79

Front Bowl Tine with Sleeves

Sold individually.

$25.85

Upper Spray Arm with Retainer

This upper spray arm helps distribute water from the top of the dishwasher tub.

Door Latch Hook

$5.38

Actuator Lever

$21.48

Motor Shaft Seal

This seal has a rubber exterior and a metal interior.

$6.87

Actuator Lever Pivot Pin

$4.63

Access Panel Insulation

$9.94

CONNECTOR

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Water dripping from right corner of door

  • Customer: Tim from Ringgold, GA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver
  • 550 of 558 people found this instruction helpful
Took out about 7 torx screws to remove the inner door liner. Discovered evidence of leak coming from the sop dispenser latch, and noticed the grommet had turned soft and was torn. The grommet is only about 1" square. Used nut driver to remove two screws to remove latch assembly. Slipped old grommet off and put new one on, and reattached the latch. The foam s... read more

Rack roller broke

  • Customer: Kathy from Lombard, IL
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 481 of 482 people found this instruction helpful
I opened the end stop of the rack, replaced the roller, and put the end stop back on. I can't believe I paid the repairman the last time $125????? An he put in a regular screw that rusted and broke the roller. Took me 3 minutes! Thanks read more

The dish rack had two sets of adjustable tines that had never worked.

  • Customer: frank from kenmore, WA
  • Difficulty: Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required:
  • 477 of 481 people found this instruction helpful
I ordered two clips just in case. Turns out I needed both of them. Since I hadn't seen the adjustable tines installed, it took some time to figure out how to put the assembly together.

For some reason I had the dishwasher for 7 years before it occurred to me to order the replacement parts. It's much more efficient to use with the adjustable tin... read more