All Installation Instructions for Maytag Dishwasher MDB6000AWW

Dishwasher Leaks

Installing the door gasket is relatively easy, it just pushes in place without any adhesive. Just make sure it is even on both sides
You can to pull it out and reinstall to even it all way around the door if needed.
You may also find a new gasket will make to door a little harder to close. I presume it will be easier to close over time.
I also installed a new float at the same time but that repair is very difficult, takes specialized tools and lots of patience.

Parts Used:

Door Gasket

Tom from Gainesville, FL
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins

Was this instruction helpful to you?

Thank you for voting!

Rusted and broken tines on dishwasher racks

I looked through the pictures of parts and discovered I could order just the worst of the broken tines...front bowl tine with sleeves and rear bowl tine! I ordered them one day and they were delivered the next day....no special shipping! I was very happy with this solution and was able to install them very easily. My dishwasher is not perfect but it is much better than it was and I am sure this "repair" will mean Ii can use the dishwasher for several more years! Thank you!

Parts Used:

Front Bowl Tine with Sleeves

Rear Bowl Tine

Ann from BRUNSWICK, ME
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

bottom of basket was broken

replaced basket with a new one, so easy even a cave man could do it.....i think.......

Parts Used:

Silverware Basket - Gray

donald from arnold, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

would not pump water in the machine.

look the instrution on line and it worked great.

Parts Used:

Water Inlet Valve - 120V

Della from Nauvoo, AL
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers, Socket set

Was this instruction helpful to you?

Thank you for voting!

old broken silverware basket

I put the new one in and that was all

Parts Used:

Silverware Basket - Gray

Vincent from Laurel Springs, NJ
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

Suspected Door Springs broken

After I got the new springs, I pulled the dishwasher out and the springs were fine but the little plastic piece that attaches the spring to the door was gone. So now I had to order the that piece and wait again.

Parts Used:

Door Spring

Charles from Titusville, FL
Difficulty Level:
Easy
Total Repair Time:
1- 2 hours
Tools:
Screw drivers, Wrench set

Was this instruction helpful to you?

Thank you for voting!

spray arm would not stay in place

Just snapped in plastic retainer and works just fine now

Parts Used:

Spray Arm Snap Retainer

Gwen from Dallas, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

Part worn out, needed to replace

No repair, just an replacement. Would recommend this company for good service.

Parts Used:

Silverware Basket - Gray

Ronald from Tulsa, OK
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers

Was this instruction helpful to you?

Thank you for voting!

weak spray was leaving the dishes uncleaned

removed the lower dish basket; used pliers to undo the lock screw. removed the lower spray arm, transfered heat shields from old part to new, replaced the lower spray arm, hand tightened the lock screw, replaced the lower dish basket....DONE!

Parts Used:

Lower Spray Arm

Edward from La Habra, CA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers

Was this instruction helpful to you?

Thank you for voting!

Dishwasher would not run unless door was held in

The fix was straight forward and easy to figure out. I followed the very easy instructions to learn any tips that would make the job go without any problems.

Parts Used:

Door Switches and Holder Assembly

Gerald from Sparta, TN
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver, Pliers, Screw drivers

Was this instruction helpful to you?

Thank you for voting!

The door of my may tag dishwasher fell down

I replace 2 springs in 10 minutes works very nice. thank you.

Parts Used:

Door Spring Linkage

Door Spring

francesco from teaneck, NJ
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

Dishwasher would not run through complete cycle

Followed the instructions provided by Parts Select. com to replaced the switches inside the door. Worked like a charm. Sandy

Parts Used:

Door Switches and Holder Assembly

Sandra K. from Newnan, GA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers

Was this instruction helpful to you?

Thank you for voting!

lack of two wheels

Replacement part has only 6 wheels. The original part has 8 wheels. The lack of the two extra wheels allows the dish rack to get stuck in the space between the inside of the dishwasher and the door. The extra set of wheels allows the rack to bridge the gap. It is a problem even if you put the rack in the other way around only a bit worse to deal with. The part was designed with four sets of wheels for a reason.

Parts Used: