Quick Question!

Have you ever purchased from PartSelect.com before?

Models > MC8130XAB0

MC8130XAB0 Whirlpool Wall Oven - Overview

Get Parts and Repair Help for MC8130XAB0

If you know the wall oven repair part you need, you can browse the list of all parts on the MC8130XAB0, or you can search by name or part description. You can also find your part by where it is located on the MC8130XAB0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your wall oven. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Manuals & Care Guides for MC8130XAB0

Click to download
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$3.02

SCREW

Sold individually.

$52.44

Door Interlock Switch Kit

This part is a genuine manufacturer door interlock switch kit, also known as primary micro switch or microwave switch kit, for a microwave. The function of this part is to sense when the door of the microwave is open or closed. If the part is defective, the microwave will not start or will start when door is open. This kit contains two 15 Amp, 125/250 Volt switches with 3/16 inch terminals. Be sure to disconnect power to microwave before replacing part. Use extreme caution when replacing microwave parts, as high-voltage capacitors can retain an electrical charge when unplugged.

$3.19

SCREW

Sold individually.

$6.57

FUSE

$4.94

Washer, Spring Lock

$2.90

SCREW

Sold individually. For white and almond models.

$4.87

Screw

Sold individually.

$25.72

Diode

This part allows power to go one way but not the other.

$69.17

High-Voltage Capacitor - 2100V 50/60Hz .95Uf

$205.33

Magnetron

Common Symptoms of the MC8130XAB0

[Viewing 1 of 1]
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Microwave worked intermittently depending on how door was closed

  • Customer: Robert from Bainbridge Island, WA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 63 of 74 people found this instruction helpful
Remove top grille (2 screws), undo control panel (1 screw). Tilt down control panel, switches are on the left. There are actually three switches that are involved with the door, two horizontally mounted, one vertically mounted. This would be an EASY REPAIR, but it took me a while to figure out which of the three switches was bad, and also took a while to ... read more

Microwave went dead while in use.

  • Customer: Keith from Georgetown, TX
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 30 of 36 people found this instruction helpful
1. removed vent across the top to gain excess to Screw holding control in place. 2. Removed control panel to access Fuse. 3. Remover fuse after pulling plug. 4.Tested fuse for continuity with volt ohm meter noting no continuity.5. Orderd new fuse. 6. receeived new fuse and installed infuse holder.7. plugged microwave plug back in receptical and tested unit n... read more

Close the door on the microwave, punch in the # nothing happened

  • Customer: Robert S. from Stafford, TX
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 14 of 20 people found this instruction helpful
I removed the unit from the wall. Took the cover off. Set the unit on its side. It revealed the working parts. Removed the old micro switches. Put in the new oness. Presto, it worked. Very easy for me.
The parts was delivered almost before my notice they were shipped. read more