Models > MAH8700AWW > Instructions

MAH8700AWW Maytag Washer - Instructions

All installation instructions for MAH8700AWW parts

These instructions have been submitted by other PartSelect customers and can help guide you through the washer repair with useful information like difficulty of repair, length of repair, tools needed, and more.

All Instructions for the MAH8700AWW
61-64 of 64
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Odd noise when the spin cycle started, water would not drain, D5 error.

  • Customer: Anthony from Holbrook AZ
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers, Wrench set
  • 0 of 0 people found this instruction helpful
The washer comes up with the D5 error if either the door is not shut correctly, or it can not detect that the washer is drained. I had to put the washing machine on its side to access the bottom. There is an access hole that you can get the pump from. I unplugged the pump, then removed the bolts to take it out. The pump comes apart with a few screws removed. I saw that the magnet inside was broken in half. Putting a new pump back in solved the issue.

drain pump runs continuously

  • Customer: Joe from Greenfield MA
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Checked owners manual for diagnostics. Pointed to door lock mechanism, so we replaced. didnt work. Went online to Just Answers.com, chatted with pro named Mike(for the fee of $25) and without getting full description, he told me to replace pressure sensor. Bought one here for $50, replaced it, and still the problem lingered. Called a real Technician to the house, for $90, and he spent 4 minutes looking and tapping, and voilla, it worked. Turns out it was a stuck relay on the control board, and the tapping loosened it. He told me I may have trouble with it in the future. If so, I would buy one here. Thanks

I was getting an "nd" error code with every wash cycle.

  • Customer: Timothy from Bismarck ND
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers, Socket set
  • 0 of 0 people found this instruction helpful
I removed the back service panel and checked the drain hose for any debris and checked the connection from the tub basin to the drain pump. I then check the drain pump and noticed the impeller blades were a bit worn. After the new drain pump arrived, I did have to swap the old intake housing with the new one in order for the whole thing to mount to the shock-absorbing mounting plate. Reconnected both hoses and the electrical connection and everything ran great!

Hot water would not shut off when wash temperature selected was hot or warm.

  • Customer: William from Charleston SC
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
Disconnected power cord. Shut off water supply. Disconnected hot water supply hose. Removed top cover. Disconnected appliance connection to Hot Water Control Valve. Removed screws holding HWC valve. Removed existing HWC valve. Installed new HWC valve. Reconnected appliance connection. Reconnected water supply hose. Turned on water to check for leaks. Reconnected power supply. Started washer with hot cycle selected. Timed water fill time. Replaced top cover. Washed a load of whites in hot water. Installation and test complete.
All Instructions for the MAH8700AWW
61-64 of 64