Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
Below is a list of all parts for the Amana Washer LWD70AW - Top Loading. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.
This triangular main tub bearing assembly is five inches long. It is made of metal.
This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.
This shaft is made to fit the center of the idler pulley wheel of many clothes dryers. It is less than two inches long, and is made of metal.
This idler spring is almost four inches long. It is made of metal.
This hose is almost 5 feet long and now comes with the washers for proper installation. It is used to bring water into your washer for the cycles.
This knob accepts a D-shaped shaft.
This tall tub spring is used for many washing machines and clothes dryers. It is twelve inches long and is made entirely of metal.
This brake pad kit contains three brake pads and six installation screws. Helps to bring a rotating cycle to a stop.
Found at the end of the inlet hoses.
This kit comes with hub, seal head, gasket, seal shroud, seal seat, screw, spline insert, drive bell and seal.
Included in this kit are the clamps for the drain hose.
This part helps stop the washer from overflowing.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.