Models > LW6163WM

LW6163WM Maytag - Overview

Parts and Repair Help for models starting with LW6163WM

If you know the repair part you need, you can browse the list of all parts for models starting with LW6163WM, or you can search by name or part description. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your . We’ve also included any installation videos we have for LW6163WM parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Models starting with LW6163WM

$4.46

Thrust Washer

$2.70

Retaining Ring

Sold individually.

$2.70

Screw

This screw is sold individually.

$51.93

Pump

This pump is attached to the motor and helps expel water from the washing machine. It is activated after the spin speed is maintained for a specific period of time.

$3.76

Adjustable Levelling Leg

Sold Individually. This adjustable leveling leg comes with a stop nut.

$2.70

Screw

This screw is sold individually.

$2.70

Hose Clamp

$14.06

V-Style Drive Belt

$2.03

Lid Hinge Mounting Screw

Sold individually.

$2.70

Hose Clamp

This hose clamp is sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

THE SEAL ON THE BOTTOM OF THE TUB WAS LEAKING

  • Customer: HOWARD from CORTLAND OH
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers, Socket set, Wrench(Adjustable)
  • 29 of 35 people found this instruction helpful
REMOVED THE FRONT OF THE WASHER, THEN LIFTED THE TOP UP AND HELD IT UP WITH A PROP. PULLED THE AGITATOR STRAIGHT UP AND STARTED THE DISASEMBLY. USING THE PHOTOS IN THE HUB AND SEAL KIT WAS A BIG HELP. THE LARGE NUT ON THE OUTPUT SHAFT HAD TO BE CUT OFF WITH MY DREMEL TOOL AND THE HUB REMOVED WITH A WHEELER PULLER. ASSEMBLY WAS PRETTY MUCH STRAIGHT FORWARD. P... read more

Frayed V-belt

  • Customer: John from Milton PA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 27 of 30 people found this instruction helpful
VERY EASY!!!
SAFETY FIRST-Always unplug the appliance.
Use 8mm socket to remove front panel screws. Loosened up two hose clamps connected to the pump and removed both lines (Hoses contain water, use a towel) which is located underneath the motor. Disconnect motor electrical connector on the left side of the motor. With socket, remove 4 mounting bra... read more

Water leaking on floor from "mysterious place underneath washer"

  • Customer: Bryan from Chicago IL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Socket set
  • 23 of 26 people found this instruction helpful
Water was leaking on the floor during the wash cycle and especially during draining of the washer. I removed the front panel at ground level and watched while draining after a rinse.

I t was obvious that water was spraying from a hole in the rubber end of the hose (the hose is a fused assembly of a plastic section and a rubber section).

read more