Models > LW4603L

LW4603L (P1163404W L) Amana Washer - Overview

Get Parts and Repair Help for LW4603L

If you know the washer repair part you need, you can browse the list of all parts on the LW4603L, or you can search by name or part description. You can also find your part by where it is located on the LW4603L by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for LW4603L parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$4.46

Thrust Washer

$2.70

Retaining Ring

Sold individually.

$2.70

Screw

This screw is sold individually.

$45.09

Drain Pump

This pump is attached to the motor and helps expel water from the washing machine. It is activated after the spin speed is maintained for a specific period of time.

$2.70

Hose Clamp

$2.03

Lid Hinge Mounting Screw

Sold individually.

$2.70

Screw

This screw is sold individually.

$3.76

Adjustable Levelling Leg

Sold Individually. This adjustable leveling leg comes with a stop nut.

$2.70

Hose Clamp

This hose clamp is sold individually.

$20.64

Drain Hose with Rubber Elbow

This hose attaches to the pump to help remove the water out of the washer.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Frayed V-belt

  • Customer: John from Milton PA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 29 of 33 people found this instruction helpful
VERY EASY!!!
SAFETY FIRST-Always unplug the appliance.
Use 8mm socket to remove front panel screws. Loosened up two hose clamps connected to the pump and removed both lines (Hoses contain water, use a towel) which is located underneath the motor. Disconnect motor electrical connector on the left side of the motor. With socket, remove 4 mounting bra... read more

THE SEAL ON THE BOTTOM OF THE TUB WAS LEAKING

  • Customer: HOWARD from CORTLAND OH
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers, Socket set, Wrench(Adjustable)
  • 30 of 37 people found this instruction helpful
REMOVED THE FRONT OF THE WASHER, THEN LIFTED THE TOP UP AND HELD IT UP WITH A PROP. PULLED THE AGITATOR STRAIGHT UP AND STARTED THE DISASEMBLY. USING THE PHOTOS IN THE HUB AND SEAL KIT WAS A BIG HELP. THE LARGE NUT ON THE OUTPUT SHAFT HAD TO BE CUT OFF WITH MY DREMEL TOOL AND THE HUB REMOVED WITH A WHEELER PULLER. ASSEMBLY WAS PRETTY MUCH STRAIGHT FORWARD. P... read more

Water leaking on floor from "mysterious place underneath washer"

  • Customer: Bryan from Chicago IL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Socket set
  • 23 of 26 people found this instruction helpful
Water was leaking on the floor during the wash cycle and especially during draining of the washer. I removed the front panel at ground level and watched while draining after a rinse.

I t was obvious that water was spraying from a hole in the rubber end of the hose (the hose is a fused assembly of a plastic section and a rubber section).

read more