Models > LW3603W (P1110504W W)

LW3603W (P1110504W W) Amana Washer - Overview

Get Parts and Repair Help for LW3603W

If you know the washer repair part you need, you can browse the list of all parts on the LW3603W, or you can search by name or part description. You can also find your part by where it is located on the LW3603W by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the LW3603W [Viewing 1 of 1]

$26.45

Main Tub Bearing Assembly

$119.75

Complete Hub and Seal Kit

This kit comes with hub, seal head, gasket, seal shroud, seal seat, screw, spline insert, drive bell and seal.

$25.41

Drive Bell and Seal Kit

This washing machine drive bell and seal kit comes with a seal, a plug, a shoulder screw, a drive bell, and some grease.

$50.18

Flex Vane Agitator

This white agitator is used for belt driven washing machines.

$3.81

FLINGER

$2.70

Lock Nut

$26.37

GASKET

$36.70

Fabric Softener Kit

This part is on top of the agitator and automatically dispenses the liquid fabric softener at the right time during the wash cycle.

Self Cleaning Lint Filter DISCONTINUED

$24.88

Lock Nut Spline Insert

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

THE SEAL ON THE BOTTOM OF THE TUB WAS LEAKING

  • Customer: HOWARD from CORTLAND OH
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers, Socket set, Wrench(Adjustable)
  • 29 of 35 people found this instruction helpful
REMOVED THE FRONT OF THE WASHER, THEN LIFTED THE TOP UP AND HELD IT UP WITH A PROP. PULLED THE AGITATOR STRAIGHT UP AND STARTED THE DISASEMBLY. USING THE PHOTOS IN THE HUB AND SEAL KIT WAS A BIG HELP. THE LARGE NUT ON THE OUTPUT SHAFT HAD TO BE CUT OFF WITH MY DREMEL TOOL AND THE HUB REMOVED WITH A WHEELER PULLER. ASSEMBLY WAS PRETTY MUCH STRAIGHT FORWARD. P... read more

tub leaking water

  • Customer: Raymond from East Sandwich MA
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Socket set, Wrench set
  • 16 of 19 people found this instruction helpful
Took off the agitator, removed inner tub, exposing the hub drive. Found fusion between hub drive and agitator shaft. Rather than using a wheel puller as instructions recommended I got my masonry hammer and removed the drive hub in pieces. Removed debris from the tub. Installed sealant around lower seal as instructed. Re-assembled inner tub, agitator with... read more

Bearing went out causing lots of noise.

  • Customer: mike from hull IA
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set, Wrench set, Wrench(Adjustable)
  • 15 of 17 people found this instruction helpful
This is not a bad repair, but give yourself some time. I did not have to take the tranny and motor out, but the inner and outer tub and all related parts had to come out, along with the outer tub base. If you are replacing the tub bearing, you HAVE to order the seal kit. Don't try to skimp like I did, since you will need the seal kit as this is what causes t... read more