Models > LW2501W (P1118404W W)

LW2501W (P1118404W W) Amana Washer - Overview

Get Parts and Repair Help for LW2501W

If you know the washer repair part you need, you can browse the list of all parts on the LW2501W, or you can search by name or part description. You can also find your part by where it is located on the LW2501W by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for LW2501W parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$4.46

Thrust Washer

$2.70

Retaining Ring

Sold individually.

$2.03

Lid Hinge Mounting Screw

Sold individually.

$2.70

Screw

This screw is sold individually.

$3.76

Adjustable Levelling Leg

Sold Individually. This adjustable leveling leg comes with a stop nut.

$2.70

Spring Retaining Clip

This front cover spring retaining clip is not quite an inch long. It is made entirely of metal and is used for some washing machines.

$2.70

Hose Clamp

This hose clamp is sold individually.

$14.68

V-Style Drive Belt

$2.70

SCREW

Sold Individually.

$26.45

Main Tub Bearing Assembly

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Frayed V-belt

  • Customer: John from Milton PA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 29 of 33 people found this instruction helpful
VERY EASY!!!
SAFETY FIRST-Always unplug the appliance.
Use 8mm socket to remove front panel screws. Loosened up two hose clamps connected to the pump and removed both lines (Hoses contain water, use a towel) which is located underneath the motor. Disconnect motor electrical connector on the left side of the motor. With socket, remove 4 mounting bra... read more

THE SEAL ON THE BOTTOM OF THE TUB WAS LEAKING

  • Customer: HOWARD from CORTLAND OH
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers, Socket set, Wrench(Adjustable)
  • 30 of 37 people found this instruction helpful
REMOVED THE FRONT OF THE WASHER, THEN LIFTED THE TOP UP AND HELD IT UP WITH A PROP. PULLED THE AGITATOR STRAIGHT UP AND STARTED THE DISASEMBLY. USING THE PHOTOS IN THE HUB AND SEAL KIT WAS A BIG HELP. THE LARGE NUT ON THE OUTPUT SHAFT HAD TO BE CUT OFF WITH MY DREMEL TOOL AND THE HUB REMOVED WITH A WHEELER PULLER. ASSEMBLY WAS PRETTY MUCH STRAIGHT FORWARD. P... read more

Bearing went out causing lots of noise.

  • Customer: mike from hull IA
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set, Wrench set, Wrench(Adjustable)
  • 16 of 18 people found this instruction helpful
This is not a bad repair, but give yourself some time. I did not have to take the tranny and motor out, but the inner and outer tub and all related parts had to come out, along with the outer tub base. If you are replacing the tub bearing, you HAVE to order the seal kit. Don't try to skimp like I did, since you will need the seal kit as this is what causes t... read more