Refrigerator Air Filters are a key component for neutralizing odors and ensuring a fresh stream of air into your refrigerator. Swapping your old filter out for a fresh one isn’t difficult and should t...
This is a micro switch for various models of LG refrigerators. This switch is responsible for turning the ice dispenser on and off within the freezer compartment of the fridge. If this switch is damag...
This water tubing clip holds the water fill tube in place in your refrigerator. The water fill tube attaches and supplies water to the ice maker/water dispenser in your fridge-freezer. If the tubing i...
This refrigerator door handle is compatible with various models of LG fridges. The handle is attached to the exterior of the refrigerator door, allowing you to easily open and close the appliance. It ...
Ask our experts a question about this model and we'll get back to you as soon as possible!
5 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Jim
February 11, 2024
I tried to replace the air filter on this model and the filter cover broke apart while I was trying to turn it. How do I get a replacement cover? I don’t need a filter and I don’t see a replacement cover on any of the diagrams.
For model number LRMDS3006S
Hello Jim, thank you for contacting us. The air filter cover you are looking for does not come separately. It comes along with the multi duct assembly, part number PS12749852. If you require assistance to place an order, please contact customer service!
water filter holder will not hold the filter. turns in ok but pops out as soon as you press the water dispenser.
For model number LRMDS3006S
Hi Mike, thank you for the question. Based on our research, if the water filter head, part number PS12580469, does not hold the filter properly, then it is most likely faulty and may need to be replaced. We hope this solves your problem!
Hi Mike, thank you for getting in touch. The water filter assembly for your model is part number PS12724758. It includes the reservoir that holds the water for the dispenser and the filter head that holds the water filter. We hope this information helps!
This couldn't have been easier. Two tiny screws in the front needed unscrewed, and then two plastic clips in the middle just had to be popped lose. Finally, you unplugged the power cord. Then, you just needed to reverse the process by plugging the new ice maker in, popping the clips in place, and screwing the two holes back in and turning
... Read more the whole thing on. Voila! Perfect ice cubes again. And for only a little over $100.
Removed ice dispenser and display with small screwdriver from front of the fridge. Pried out the whole piece slowly. This exposed the motor that activates the chute. Plugged in the new motor before any removal to verify the motor was the problem. When it worked, removed old and installed new. 3 screws. Piece of cake.
Unplug the refrigerator and empty the freezer. Remove the lower basket and roll out upper tray. Open the freezer door. I was able to lie on the floor to remove the 2 screws holding the ice maker without removing the freezer door. Depress the 2 tabs and slide the ice maker forward to remove. Install in reverse order. Change the wate
... Read morer inlet valve at the same time.