Models > LHD65EBL LG

LHD65EBL LG Dehumidifier - Overview

Get Parts and Repair Help for LHD65EBL

If you know the dehumidifier repair part you need, you can browse the list of all parts on the LHD65EBL, or you can search by name or part description. You can also find your part by where it is located on the LHD65EBL by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dehumidifier. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the LHD65EBL [Viewing 1 of 1]

$15.41

Sensor

Also known as thermistor.

$3.06

Roller Assembly

$6.34

Filter,Air

$16.79

PCB Assembly,Display

$20.11

Power Cord Assembly

$71.61

PCB Assembly,Main

$6.34

Switch Assembly

$6.34

Fan,Turbo

Connector,Hose

$12.93

Overload Protect

Common Symptoms of the LHD65EBL [Viewing 1 of 80]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

bucket full light constantly blinking with error code 01 on the display

  • Customer: Seif from DETROIT MI
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
Unscrew and detached front and back panels, and inside framework holding the sheet metal to the body, after removing the sheet metal, unscrew the box enclosing the control board, use needle nose pliers to unhook the sensor module from the board and place the new sensor into the spots where the old sensor was connected (thermostat area, humidity Sensor, bucke... read more

broken roller wheels

  • Customer: MICHAEL from LEBANON PA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 0 of 0 people found this instruction helpful
released broken wheels from their position using a screwdriver and secured new ones w/ a pliers. read more

bucket full light was blinking and dehumidifier would run for a few seconds then turn off

  • Customer: Larry from North Ridgeville OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
remove outer shell and control panel. take cover off off electrical connection box. remove old sensor from front of condensing coil along with wiring harness to temperature sensor and bucket switch and circuit board. reinstall new sensor in the reverse procedure. reinstall covers. read more