Quick Question!

Have you ever purchased from PartSelect.com before?

Models > LGA30AW > Parts

LGA30AW (PLGA30AW) Amana Dryer - Parts

All parts for the Amana Dryer LGA30AW

Below is a list of all parts for the Amana Dryer LGA30AW - Gas. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the LGA30AW
15-28 of 157
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$22.96

Roller Bracket and Shaft Assembly

This drum support roller bracket and shaft assembly is a little over two inches long. It is made of metal.

$24.72

Blower Wheel

If your dryer is noisy, will not tumble, or is not producing enough heat, you may need to replace the blower wheel. This part is white in color, and is made of plastic. This part is approximately 8 inches in diameter. The blower wheel is located near the bottom of your dryer cabinet. To access it for this repair, you will need to remove both the front panel and the front bulkhead assembly. Before you begin this repair, be sure to disconnect the power source to the dryer. To complete this repair, you will need a 5/16 inch nut driver, a 1/4 inch nut driver, a pair of locking pliers and a 7/8 socket with a short extension and a ratchet.

$124.40

Motor Assembly (Threaded Shaft)

This 1/4 horsepower gas or electric clothes dryer motor carries 120 volts, 60 Hz, and 5.5 amps. It also performs 1725 revolutions per minute. This motor is used for some gas and so...

$4.63

Spring Retaining Clip

This spring retaining clip is just under 1 inch long. The clip is made entirely of metal and is attached to the back wall of the washer, under the console. If your washer is vibrating and louder than usual during the wash cycle, your spring retaining clip could be faulty or damaged. Check the clip for visible damage, wear, and rust. If you notice any signs of damage, the part should be replaced. Remember to disconnect the power from your washing machine before starting this repair.

$75.50

Lint Duct Assembly

This part includes the upper and lower air duct assembly and lint screen.

$15.70

Idler Pulley Lever and Shaft

This arm is what attaches to the idler pulley wheel.

$30.95

Cycling Thermostat

This cycling thermostat has a limit of 153 degrees Fahrenheit, meaning that your dryer will cut out when the internal temperature reaches 153 degrees. It kicks back in though, when...

$14.42

Idler Pulley Shaft

This shaft is made to fit the center of the idler pulley wheel of many clothes dryers. It is less than two inches long, and is made of metal.

$3.02

Screw

Sold Individually.

$35.33

High Limit Thermostat

If you notice that your dryer will not start, shuts off too soon or provides too much heat, you may need to replace your high limit thermostat. This high limit thermostat acts as a safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this piece will shut down power to the heating element. The high limit thermostat is in the rear of the dryer behind the back panel. To complete this repair, you will need to remove the back panel of your dryer. Be sure to disconnect power to the dryer before beginning this repair.

$23.32

Thermostat Boosting Heater

This thermostat heater is two inches long. It is beige/brown in color and is made of plastic.

$4.87

Single Felt Pad

This pad is used for many clothes dryers. It is made of a felt material and it is a little over an inch long.

$24.04

Idler Pulley Spring

At just two and a half inches, this metal spring fits onto the arm of the idler pulley assembly of gas and electric clothes dryers.

$4.63

Clamp-Motor

This clamp is used to secure the drive motor.

All Parts for the LGA30AW
15-28 of 157