Quick Question!

Have you ever purchased from PartSelect.com before?

Models > LG3412L

LG3412L (P1122505W L) Amana Dryer - Overview

Get Parts and Repair Help for LG3412L

If you know the dryer repair part you need, you can browse the list of all parts on the LG3412L, or you can search by name or part description. You can also find your part by where it is located on the LG3412L by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for LG3412L parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$15.40

'M' Series New Style Coil Kit

This gas dryer ignition coil set comes with two ignition coils: one three terminal Boost/Hold coil, and one two terminal secondary coil. Usually only one of them burns out but you ...

Order within the next 4 hrs and your part ships today!
$18.75

Door Switch Kit

This part replaces older two terminal switches.

Order within the next 4 hrs and your part ships today!
$16.63

Door Catch Kit

This kit comes in two pieces: the catch and the clip.

Order within the next 4 hrs and your part ships today!
$24.69

Blower Wheel

Part may differ in appearance, but functions same as original part.

Order within the next 4 hrs and your part ships today!
$35.48

High Limit Thermostat

This hi-limit thermostat acts as a safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this piece will shut down power to th...

Order within the next 4 hrs and your part ships today!
$4.79

Leveling Leg

Order within the next 4 hrs and your part ships today!
$32.54

HOUSING- B

Order within the next 4 hrs and your part ships today!

Rubber Leveling Leg Foot Pad

This gray levelling leg foot pad is made of rubber and is just over an inch in diameter.

Lock Nut

Igniter Kit

This flat style gas dryer igniter kit includes an igniter and the bracket that goes with the igniter. The glow bar silicone carbide gas dryer igniter has a ceramic tip, and is just under 9 inches in total length.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Dryer ran but would not heat

  • Customer: Gary from Haverhill, NH
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 275 of 311 people found this instruction helpful
PartSelect showed seven different possibilities why the dryer wouldn't heat. I removed the two screws to remove the bottom panel and turned the dryer on and noticed that the heating element that ignites the gas was working fine. This meant that it was not getting gas so it could be the gas valve or one of the two gas valve coils which are located on top of t... read more

Replace drive belt

  • Customer: Robert from Skokie, IL
  • Difficulty: Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver
  • 232 of 270 people found this instruction helpful
Remove front panel, lint basket, motor mounts,exhaust hood, front drum brackets. Then slip serpentine belt around drum, pressure w/ tension idler pulley and slip around drive motor spindle. Replace all parts in reverse order (a two person job).
Vacuumed inside of dryer (full of lint.) read more

Timer wasn't working (New Timer)

  • Customer: Joaquin from Las Vegas, NV
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 120 of 68 people found this instruction helpful
Timer wasn't working on the regular cycle so I replace it with a new one from partselect. It still wasn't working so I ordered and replace the cycling thermostat, the thermal fuse I also cleaned the vent and dryer it still didn't work so I read the diagram for the electrical and found that a coil for the gas valve is line with timer. I ordered the coils for ... read more