Models > LG2902

LG2902 (P7804817W W) Amana Washer - Overview

Get Parts and Repair Help for LG2902

If you know the washer repair part you need, you can browse the list of all parts on the LG2902, or you can search by name or part description. You can also find your part by where it is located on the LG2902 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the LG2902 [Viewing 1 of 1]

$71.10

Heating Element Kit - Red Dot

This 240 volt heating element is used for electric clothes dryers. Included with this element is a fuse kit consisting of a thermal fuse, a high limit thermostat, two wire leads, a...

$3.82

Screw

This screw is sold individually.

$3.82

Screw - 12-14 x 1/2 Type B

$3.82

SCREW

$133.84

Heating Element (White Dot)

This 208 volt heating element is used for some of Amana/Speed Queen's brands of electric clothes dryers.

High Limit Thermostat - L300-40

This hi-limit thermostat acts as as safety mechanism that keeps the dryer from overheating. With this thermostat, a dryer's heating element will cut out if the internal temperature reaches 300 degrees Fahrenheit. The element will kick back in when the temperature drops to 260 degrees Fahrenheit - the differential of 40 degrees.

Heater Duct Assembly

NUT, SCREW

INSULATOR

LOCKWASHER

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Heating element went bad

  • Customer: Jeff from Conyers GA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 23 of 24 people found this instruction helpful
I couldn't find any information on the internet on how to fix my dryer, so I took every screw out of it, which I later found was not needed - just 2 in the front. Then I had to figure out WHERE the element was. Turns out, against the back panel with 2 screws. I had to crawl on my belly to get in there with little room to work. Installing the new one didn't t... read more

Taking too long for clothes to dry.

  • Customer: James from Eagle ID
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 16 of 18 people found this instruction helpful
I first unplugged the dryer (don't want to get nailed with 240 volts). I then removed the two screws on the bottom section of the dryer just below the door. I then removed the two screws on the front door assembly and removed the door (make sure you don't break the wires and/or door switch. The wires need to be removed from the door switch prior to removi... read more

Dryer stopped heating

  • Customer: Doneen from Provo UT
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 8 of 10 people found this instruction helpful
I removed the screws that hold the element in place. I disconnected the wires. I took the new part, which was easy to identify and order, assembled per instructions, and attached it to the wires in the dryer, then screwed it in. I normally let my husband do these repairs, but he wasn't available. It was easy and the dryer works perfectly again! read more