LER7646EQ2 Whirlpool Dryer - Instructions

I removed the 9 screws from the back plate of the dryer. I cleaned all the lint off the wires and the entire back of the unit with a paint brush and vacuum cleaner. Then I removed each part with a nut driver, also removing the wires and replaced each part in less that 1/2 hour! The videos were a huge help. Now my 16 year old dryer works like new. Saved lot of $$$. Thanks Partselct you're the Greatest!

Let me put it to you this way I called the repair man and they would Charge me $150 to get the dryer fixed,by ordering the parts I spent $32 and 15 minutes installing it with the instruction video very easy to do Take the advice it yourself and save yourself some money $$$ With The extra cash I took my wife out for dinner Now that's money well spent...

Disconnected electrical output, closed gas valve and line. Removed back of dryer and removed wires to thermostat and replaced with new thermostat. Did not solve problems.

Disconnected electrical outlet, closed gas valve and removed line. Removed back of dryer and disconnected wires to fuse. Did not solve problem.

After diagnosing, easy removal and install.

Traced down where power stopped, put jumper in place of the thermal fuse anew found this was the problem. Ordered the part from part select

very simple. actually did a little more then was necessary. once we removed the back of the dryer, used our vacuum to vacuum up all the lint that was back there. Watched the video on how to repair the part when we ordered it and it was easy as can be.. we have used this web site to repair our oven, fridge and now the dryer. Everything went according to plan. I reccomend this site as much as i can and it has saved us a lot of money. Thank you!

When I initially inspected the dryer when it stopped working, I noticed a ball of lint had collected on the backside of the thermal fuse. I figured that had allowed the temperature to exceed the fuse's max temp. To relace, I simply removed the dryer's rear panel, disconnected the thermal fuse and replaced it. Once all back together, the dryer powered on with no problem.

Pulled back off the dryer replaced heating element following the directions on PartSelect.com Thank you for being a great website. You also helped me with my 10yr old Washer two months ago. i especially love the how to videos.

I opened up the instrument panel box using philips screw driver and found the repair instructions. Followed the symtom diagnostic page and found that if the machine can be turned on but motor not working then check thermal fuse or motor. Next, I unplugged the appliance and remove the back panel to locate where the thermal fuse and other parts per the diagram in the repair instructions. Using a volt meter, I removed the electrical plugs to the thermal fuse and check resistance (a 1 on the volt meter indicated that the fuse is open (or burned)). Removed the thermal and checked for part number and looked up the model and parts number on the internet. Took a chance and ordered the part. When the order arrived 3 days later, I just simply replaced it and put everything back to where they were. Hooked up the power supply and turned on the dryer. It works again!! One thing I found was that I needed to clean the air pipe since it was totally clogged and probably caused the machine to overheat and burn out the fuse.

Took the old part off and replaced it with the new one.

pretty simple fix not much to it. If you are familiar with electrical work a dryer is just about as basic as it gets. Thermal fuse was bad, swapped it out and up and running again. It took me longer to get the dryer pulled out and cleaned up, than it did to replace the fuse. Wow was it diry back there!

repair was simple

Very easy to installation,first belt has to go on drum and then through pulley,pulley go on it`s place ,need some pressure on pulley to instal it.Very easy.Thank`s for fast belt delivery. Richard

watched the video and it couldn't have been easier