Quick Question!

Have you ever purchased from PartSelect.com before?

Models > LE4217L2

LE4217L2 (PLE4217L2) Amana Dryer - Overview

Get Parts and Repair Help for LE4217L2

If you know the dryer repair part you need, you can browse the list of all parts on the LE4217L2, or you can search by name or part description. You can also find your part by where it is located on the LE4217L2 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for LE4217L2 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$13.36

Multi Rib Belt - 93-3/8"

At 93-3/8" inches in length, this dryer drum belt from Amana has five ridges. It is all black in color and is made entirely of rubber. A flat belt, it is 3/8 of an inch wide.

$8.51

Drum Support Roller - for square ported models

This single drum support roller is used for square ported model clothes dryers. It has a metallic bearing in its center.

$6.47

Drum Glide

This drum glide is sold individually. ***Please Note: these should be replaced in pairs.

$4.89

High Limit Thermal Fuse

Meant as a backup to a high limit thermostat, this fuse is typically set to trip at a higher temperature than that of a high limit thermostat. This is a one-time use fuse, so when it does trip, you do need to replace it. It's letting you know that something is wrong with your dryer.

$16.23

Idler Lever

The spring for this part is sold separately.

$7.69

Idler Pulley Wheel with Bearing

This two inch wide idler pulley wheel is beige in color and is made of plastic. This pulley wheel comes with its own metallic bearing in its center.

$14.78

Door Catch Kit

This kit comes in two pieces: the catch and the clip.

$4.63

Washer, Thrust

This washer is 3/4 inches in diameter.

$16.71

Door Switch Kit

This part replaces older two terminal switches.

$17.94

Cylinder Felt Seal

This part is located between the back of the drum and the rear dryer panel.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Drum not centered , clothes getting stuck in dryer

  • Customer: Chris from Hopedale, MA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 492 of 500 people found this instruction helpful
The first thing I did was to unplug the dryer from the wall. Then I removed the bottom two screws and slid the bottom cover off so i could see all the way to the back, I tipped the dryer back against the wall and searched for the problem with a flashlight. I noticed that one of the guide wheels that held the drum in place was sheared off. I took the new d... read more

Replace drive belt

  • Customer: Robert from Skokie, IL
  • Difficulty: Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver
  • 248 of 287 people found this instruction helpful
Remove front panel, lint basket, motor mounts,exhaust hood, front drum brackets. Then slip serpentine belt around drum, pressure w/ tension idler pulley and slip around drive motor spindle. Replace all parts in reverse order (a two person job).
Vacuumed inside of dryer (full of lint.) read more

Squeeling/Screeching

  • Customer: William from Round Mountain, NV
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Socket set
  • 218 of 293 people found this instruction helpful
First I read all of the other stories about this problem so I would have the correct parts. At $6 a roller, decided to get all 3 & a belt. Pulled the lower panel off (2 bolts), then the door (2 bolts). Marked the door switch wires. Took 2 bolts out of the top & tilted it back. I found this the easiest way to access the drum. Mark 2 wires before disconnecting... read more