Quick Question!

Have you ever purchased from PartSelect.com before?

Models > LE2402 (P7762217W)

LE2402 (P7762217W) Amana Dryer - Overview

Get Parts and Repair Help for LE2402

If you know the dryer repair part you need, you can browse the list of all parts on the LE2402, or you can search by name or part description. You can also find your part by where it is located on the LE2402 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for LE2402 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$18.75

Door Switch Kit

This part replaces older two terminal switches.

$16.63

Door Catch Kit

This kit comes in two pieces: the catch and the clip.

$24.69

Blower Wheel

Part may differ in appearance, but functions same as original part.

$80.93

Heating Element Kit - Red Dot

This 240 volt heating element is used for electric clothes dryers. Included with this element is a fuse kit consisting of a thermal fuse, a high limit thermostat, two wire leads, and four mounting screws.

$4.79

Leveling Leg

$32.54

HOUSING- B

$148.65

Heating Element (White Dot)

This 208 volt heating element is used for some of Amana/Speed Queen's brands of electric clothes dryers.

Rubber Leveling Leg Foot Pad

This gray levelling leg foot pad is made of rubber and is just over an inch in diameter.

$45.70

Cycling Thermostat - Limit: 140-15

This cycling thermostat has a limit of 140 degrees Fahrenheit and a differential of 15 degrees. This means that with this thermostat, your dryer's heating element will cut out at 1...

High Limit Thermostat - L300-40

This hi-limit thermostat acts as as safety mechanism that keeps the dryer from overheating. With this thermostat, a dryer's heating element will cut out if the internal temperature reaches 300 degrees Fahrenheit. The element will kick back in when the temperature drops to 260 degrees Fahrenheit - the differential of 40 degrees.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Replace drive belt

  • Customer: Robert from Skokie, IL
  • Difficulty: Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver
  • 232 of 270 people found this instruction helpful
Remove front panel, lint basket, motor mounts,exhaust hood, front drum brackets. Then slip serpentine belt around drum, pressure w/ tension idler pulley and slip around drive motor spindle. Replace all parts in reverse order (a two person job).
Vacuumed inside of dryer (full of lint.) read more

catch mounted on door broke

  • Customer: Paul from Mt. Pleasant, SC
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 65 of 85 people found this instruction helpful
The door had always opened with the wrong swing and it wasn't til I needed to repair this that I noticed you could change the swing. I changed the swing of the door and then noticed that the clip was included on both sides so i did not need to repair the catch. I still have the part so when it breaks again, I can just pop it in. read more

Switch sticking in on position

  • Customer: Don from Jacksonville, FL
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 63 of 90 people found this instruction helpful
FIRST unplug dryer from electrical source, CAUTION, the top of this dryer does not open with clips, do not pry on top to open! On the front of the dryer look under the lower panel, and find two screws, one on the left side, and one on the right, remove these screws, and pull slightly down on panel to remove. Behind this panel find two screws holding the do... read more