Models > KUIO18NNVS2

KUIO18NNVS2 KitchenAid Ice Maker - Overview

Get Parts and Repair Help for KUIO18NNVS2

If you know the ice maker repair part you need, you can browse the list of all parts on the KUIO18NNVS2, or you can search by name or part description. You can also find your part by where it is located on the KUIO18NNVS2 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your ice maker. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.70

Screw

This screw is sold individually.

$125.91

Ice Cutter Grid Complete Assembly

Used with freestanding ice makers.

$52.70

Recirculating Pump - 60Hz

Used with stand-alone ice cube makers.

$31.02

Bin Thermostat

Used in stand-alone icemakers.

$27.57

Ice Cutting Grid Wire

There is approximately 10'of wire. Note:2 kits are needed to replace both directions.

$2.70

Screw

This screw is sold individually.

$15.15

Light Switch

$2.70

Single Hex Head Screw

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

$142.14

VALVE

$15.54

Drain Fastener Cap

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

was not making ice

  • Customer: Richard from North Wilkesboro NC
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 17 of 22 people found this instruction helpful
diagnosed no water flow over evaporator checked voltage into pump then checked pump with ohm meter ordered pump and installed by removing access cover and water holding assembly installed new pump replaced water holding assembly and access cover and returned icemaker to service all is well read more

Broken light switch

  • Customer: Randy from Hays KS
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Socket set
  • 16 of 26 people found this instruction helpful
Took all the screws out of the plastic shroud that encloses the switch .There only four that I needed to remove, were the two in front where the switches that go,they go in horizontally and two in the back with large washers on them that hold the back to the top of the box that go in vertically.The switch was a snap ( make that two snaps ) the wiring is alm... read more

the top wire on the cutting grid broke and thus no longer cut the ice. It sat on the wire until the ice melted, depositing no ice into the bin

  • Customer: Sherri from Ada OK
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Pliers, Screw drivers
  • 10 of 11 people found this instruction helpful
I removed the cutter grid and unplugged the light bulb and wire heating plug ins. I slid the front cover plate off the cutting grid and loosened the screws on the front of the cutter grid and unthreaded the broken, top grid wire, leaving the bottom wire in place as it was in tact.
I then threaded the new wire through the cutting grid frame starting in ... read more