Models > KUDV24SEBL3

KUDV24SEBL3 KitchenAid Dishwasher - Overview

Get Parts and Repair Help for KUDV24SEBL3

If you know the dishwasher repair part you need, you can browse the list of all parts on the KUDV24SEBL3, or you can search by name or part description. You can also find your part by where it is located on the KUDV24SEBL3 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for KUDV24SEBL3 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$28.56

Middle Spray Arm Kit

This kit has been redesigned. The supply tube is now one piece. This spray arm kit comes with an upper spray arm, holder, water supply tube and a screw. This kit does NOT inclu...

$4.01

Upper Spray Arm Mount

**Please note: This is a redesigned part. The top mounting clip and screw are no longer needed.

$3.96

Wash Arm Bearing Ring

This part will fit between the newer type lower wash arm and the wash arm retainer nut of your dishwasher.

$3.81

Spray Arm Seal

This white under spray arm bearing ring is designed with the split. This is not a defective or damaged item.

$4.01

Wash Arm Retainer Nut

Use this part to secure the lower spray arm of your dishwasher.

$4.01

Tinerow Clip

This clip attaches the tinerow to the rack. Sold individually.

$33.52

Drain and Wash Impeller Kit

This dishwasher drain and wash impeller kit comes with both the drain and wash impeller, gaskets, chopper and installation screw. This part helps stop your dishwasher from leaking...

$27.67

Lower Door Seal Kit

$3.96

Rubber Washer

Sold individually. Used with the heating element.

$4.11

USE WPL 8533889

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Not Cleaning lightly soiled items.

  • Customer: Dennis from Cromwell CT
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 366 of 368 people found this instruction helpful
Removed spray arm thumb nut. Removed spray arm. replaced worn and broken earings and re-assembled in reverse order. Would have done the repair a lot sooner if I had known that PartsSelect was just a few miles up the highway. read more

Water washing out under front door onto floor

  • Customer: Kent from Matthews NC
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 138 of 207 people found this instruction helpful
The plastic parts on this spray arm assembly wear with time and the rotation wobble effect creates a wave action in the pool of water at the bottom of the dishwasher. This waves the water onto the front door and forces a leak outside the unit. Replace the lower arm assembly, washer, bearing and nut. They all wear. Also remember to tighten the screws on to... read more

Lower spray arm was not turing properly and causing poor wash results

  • Customer: Robert from York PA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 115 of 179 people found this instruction helpful
I noticed the upper bushing washer was worn thin. this caused the lower spray arm to rise too high and wobble during all the wash cycles. Also the rotation of the lower spray arm was wearing grooves in the lower bushing.

I removed the retaining nut and simply replaced teh defective parts. While I was at it I figured equal wear might be evident... read more