Models > KUDI01ILBT4

KUDI01ILBT4 KitchenAid Dishwasher - Overview

Get Parts and Repair Help for KUDI01ILBT4

If you know the dishwasher repair part you need, you can browse the list of all parts on the KUDI01ILBT4, or you can search by name or part description. You can also find your part by where it is located on the KUDI01ILBT4 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for KUDI01ILBT4 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$18.96

Door Balance Link Kit

This kit includes 2 door balance links and 2 door balance mounts with wheels.

$17.77

Upper Dishrack Wheel Mount

This wheel mount is sold individually. It is located on the top dishrack with two per side.

$9.60

Mounting Bracket

Sold individually.

$39.40

Silverware Basket

$23.02

Chopper Assembly

This chopper assembly chops/minces the food particles to prevent clogging of the dishwasher pump.

$3.96

Rack Track Stop

Used for upper dishrack track.

$3.81

Upper Rack Wheel and Mount Assembly

Sold Individually.

$50.59

Detergent and Rinse Aid Dispenser

This part releases the detergent and rinse aid into the dishwasher.

$19.85

Fuse Kit

When replacing these fuses the wire harness must be replaced as well. It is located in the control panel. The harness is included with this part now.

$40.84

Door Handle

This part is no longer available in white or biscuit.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The wheel mount had broken so that the wheel was disconnected from the mount on the upper rack, making the rack unstable.

  • Customer: Elizabeth from San Francisco CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 364 of 367 people found this instruction helpful
I had to fiddle with the mount a bit to get it on the rack properly. Then I pulled back slightly on the inner part of the end piece of the track while also pulling the top of the piece back and released the inner tip of the piece, allowing the end piece to be removed. I placed the new wheel in the track and replaced the end piece.

Super easy and... read more

Replaced Hinge Link

  • Customer: Scott from Fort Lauderdale FL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 235 of 238 people found this instruction helpful
Pulled dishwasher from under counter, attached link to spring, hooked spring back into frame/chassis, threaded link through pulleys, attached other end of link onto door, reinstalled dishwasher under counter. All's well. Note-I purchased an extra link anticipating that the other one will fail. They're cheap enough. read more

Dishes on top rack of dishwasher were not being cleaned.

  • Customer: Bill from North Richland Hills TX
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers
  • 159 of 168 people found this instruction helpful
1) Remove top and bottom dish baskets from the dishwasher, this will give you room to work. To remove top basket there are clips at the end of the slide rails.
2) Remove lower spray arm by unscrewing plastic screw, it should only be hand tight.
3) In order to remove the strainer cover, you will need to remove the plastic tube that takes water to th... read more