KUDI01FLSS3 KitchenAid Dishwasher - Instructions

At first I thought that it was the feed tube but after some more thought I started diging and found the chopper broken cleaned the screen and got water to top tray so I ordered the chopper assembly and now it works fine

I removed the screws holding in the dishwasher and pulled the unit out. The broken door balance link was removed from the door balance. The door balance was removed from the dishwasher with a socket and replaced with the new balance. The new door balance link was hooked on the door and threaded through the balance, The spring was hooked into the back of the dishwasher through the frame. With the pliers the hook on the spring was grabbed, extended and the hook on the spring was fished through the door balance link. The process was repeated for the opposite side.

replaced.

The wheel mounts broke so i had to replace them. I'm the un-handiest person ever and it took about a minute to replace all four. All I had to do was take off the stops at the front of the rack and slide out the broken wheels and slide in the new ones and put the stop back on. So easy!

it about 30 min to replase this part it was easy as pie.

Removed dishrack snapped out old parts and snapped in new one. As they say a piece if cake.
Mel Shebester

pulled out the dishwasher, removed the two bolts and installed the new mounts with the same bolts, easy!

1st I had to check out what needed to be replace. After checking this web site for things gone wrong on my model. The top listed thing was the motor module for the ice maker. I went with that and order part. Once part arrived and it took 5 days. I remove old module and installed new module in about 20 minutes. 4 hours later I had ice again. The best part about this whole ordeal was the module was 40% cheaper from PartsSelect.Com and the info on here from everybodys feed back makes it easy to find the real problem. Thanks! Mike

removed toe kick, took off old hinges and replaced w/new and improved

Followed instructions in fuse kit.
The fuse had been replaced before, so I did not have to cut wires.
Repair was successful, dishwasher operational.

Easy to find part online, quick delivery, new part had different end but site claimed it fits my brand/model and it DID! One of my few true "five minute jobs"

Forget about trying to lube these hinges! This is a "known problem" relating to the nylon cord and pulley configuration. The real solution is to replace this faulty part and it's really easy to do... check out KitchenAid site for help.

Remove inner door cover and replace fuse. Wire harness was not needed.

replaced part,ice maker still not working.

I found the problem when I found one of the torque screw partially out. The door was not closing properly. The heat blow the fuse. I removed the head were the control board is found and replaced it with the new kit. When you add the new fuse kit. It is needed to cut the old wire from the old fuse and adapt the new wire harness by stripping the wire . Then screw the wire tight to the adapter. And it's done. Also make sure to test the cycle of the dishwasher ,by timing it. All came out good. It's operational.