Models > KUDI01DLBL2

KUDI01DLBL2 KitchenAid Dishwasher - Overview

Get Parts and Repair Help for KUDI01DLBL2

If you know the dishwasher repair part you need, you can browse the list of all parts on the KUDI01DLBL2, or you can search by name or part description. You can also find your part by where it is located on the KUDI01DLBL2 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for KUDI01DLBL2 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$21.19

Door Balance Link Kit

This kit includes 2 door balance links and 2 door balance mounts with wheels.

$17.35

Upper Dishrack Wheel Mount

This wheel mount is sold individually. It is located on the top dishrack with two per side.

$7.62

Mounting Bracket

Sold individually.

$33.73

Silverware Basket

$20.38

Chopper Assembly

This chopper assembly chops/minces the food particles to prevent clogging of the dishwasher pump.

$3.76

Rack Track Stop

Used for upper dishrack track.

$3.61

Upper Rack Wheel and Mount Assembly

Sold Individually.

$37.59

Water Inlet Valve

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoid on the valve will open and close according to the desired amount of water needed.

$3.76

Door Release Spring

This spring is located in the door section. Sold individually.

$50.59

Detergent and Rinse Aid Dispenser

This part releases the detergent and rinse aid into the dishwasher.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Worn dishrack wheel mount

  • Customer: Jason from Todd NC
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 465 of 468 people found this instruction helpful
This wheel mount broke from normal use and made the upper dish rack disconnect from the sliding arm that extends it outside the dishwasher body so that you can fill it. The part was delivered quickly and was easy to install using just a screwdriver to loosen the retainer clip on the end of the extension slide. Once the retainer clip was removed, the new part... read more

The wheel mount had broken so that the wheel was disconnected from the mount on the upper rack, making the rack unstable.

  • Customer: Elizabeth from San Francisco CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 368 of 372 people found this instruction helpful
I had to fiddle with the mount a bit to get it on the rack properly. Then I pulled back slightly on the inner part of the end piece of the track while also pulling the top of the piece back and released the inner tip of the piece, allowing the end piece to be removed. I placed the new wheel in the track and replaced the end piece.

Super easy and... read more

Replaced Hinge Link

  • Customer: Scott from Fort Lauderdale FL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 293 of 299 people found this instruction helpful
Pulled dishwasher from under counter, attached link to spring, hooked spring back into frame/chassis, threaded link through pulleys, attached other end of link onto door, reinstalled dishwasher under counter. All's well. Note-I purchased an extra link anticipating that the other one will fail. They're cheap enough. read more