Models > KUDC10IXSS3

KUDC10IXSS3 KitchenAid Dishwasher - Overview

Get Parts and Repair Help for KUDC10IXSS3

If you know the dishwasher repair part you need, you can browse the list of all parts on the KUDC10IXSS3, or you can search by name or part description. You can also find your part by where it is located on the KUDC10IXSS3 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for KUDC10IXSS3 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Door Balance Link Kit

This kit includes 2 door balance links and 2 door balance mounts with wheels.


Mounting Bracket

Sold individually.


Rack Stop Clip

This part goes on the end of the rail to stop the dishrack from falling out.


Spinner Kit

This is also called the 3rd-level spinner. This part works like a little spray arm at the top of your dishwasher.


Lower Dishrack

Dishrack ONLY.


Drawer Track


Circulation Pump and Motor

The part functions by spinning the impeller of the circulation pump, which is used to move the water through the spray arms during the wash cycle.


Drain Pump - 120V 60Hz

The pump ejects the water from the unit.


Tine Row

Sold individually.


Upper Rack Roller

This assembly is the wheel and the mount for your upper dishrack. Sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Replaced Hinge Link

  • Customer: Scott from Fort Lauderdale FL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 401 of 412 people found this instruction helpful
Pulled dishwasher from under counter, attached link to spring, hooked spring back into frame/chassis, threaded link through pulleys, attached other end of link onto door, reinstalled dishwasher under counter. All's well. Note-I purchased an extra link anticipating that the other one will fail. They're cheap enough. read more

dishwasher not draining after wash cycle

  • Customer: Andrew from Alexandria VA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 177 of 194 people found this instruction helpful
Caviat: The actual repair is less than 15 minutes, but I spent a lot of time playing with it before I figured out it was that easy and fast. You don't need to remove the dishwasher from the counter to do this. And it will probably help to look at the new part closely so you can understand where the retainer clip is to press it and release the old pump.
... read more

Loud grinding noise from water pump

  • Customer: Steve from Inver Grove Heights MN
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Wrench (Adjustable)
  • 133 of 144 people found this instruction helpful
Rather than remove the pump assembly - as an earlier post had done - I pulled the entire dishwasher out and laid it down on the floor. This allowed easy, direct access to the motor (that was the hard, messy part). From this point it was easy. Unplug the wiring, remove the retaining bolt, rotate the motor off the mounting brackets and pull it out. Then put th... read more