Quick Question!

Have you ever purchased from PartSelect.com before?

Models > KUCC151JBL0 > Parts

KUCC151JBL0 KitchenAid Trash Compactor - Parts

All parts for the KitchenAid Trash Compactor KUCC151JBL0

Below is a list of all parts for the KitchenAid Trash Compactor KUCC151JBL0. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the KUCC151JBL0
15-28 of 153
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$20.15

Wheel Assembly - Kit of 2

This wheel assembly, or roller assembly, is for a trash compactor. The kit includes two wheels that are approximately 1 inch in diameter each. The wheels allow the trash compactor ...

$3.02

Single Metallic Shoulder Screw - Size: 8-32 x 3\8"

Sold Individually.

$30.29

Cover, Air Freshener (Black)

Black in color.

$3.02

Support Roller Clip

Sold Individually.

$115.88

PANEL

No longer available in Almond.

$11.51

Spray Paint - 12 oz. - White

Appliance spray paint is a great way to cover up any chips and scratches that have appeared on your appliances. Instead of replacing the part entirely, this is an easy fix. This is also a great way to give a fresh new look to any handles or areas that have discoloring due to wear. Make sure to clean the area before you begin and wear a protective mask for safety. Give the can a good shake and spray a few inches away from the surface. Apply the paint until the area is fully covered as desired. Wait until the paint has dried before using the appliance.

$20.79

Power Nut Kit

Includes everything pictured above.

$64.90

HANDLE

$2.94

Nut

Sold individually.

$5.81

USE MAC 41001134

$4.79

Screw

Sold individually.

$3.81

Touch-up Paint - Almond

$3.75

Screw

This screw is sold individually. Size: 8-32 x 1/4 inch.

$181.24

Drive Motor

This drive motor is for trash compactors. The drive motor turns the gears and chain that raise and lower the compactor ram. If your trash compactor will not start or will not stay on during the compaction cycle, you may have a defective drive motor. The start or run switch is used to supply power to the motor to initiate the compaction cycle. If the windings in the motor are open or if the motor centrifugal switch is open, the unit will not start. To check for a defective motor, you will need to remove the unit from the cabinets and disconnect the power.

All Parts for the KUCC151JBL0
15-28 of 153