Models > KUCC151EBL0

KUCC151EBL0 KitchenAid Trash Compactor - Overview

Get Parts and Repair Help for KUCC151EBL0

If you know the trash compactor repair part you need, you can browse the list of all parts on the KUCC151EBL0, or you can search by name or part description. You can also find your part by where it is located on the KUCC151EBL0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your trash compactor. We’ve also included any installation videos we have for KUCC151EBL0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$16.38

15" Compactor Bags - 15 Pack

These bags will fit most 15" rectangular compactors.

$26.14

Drive Gear Kit

This kit is used for trash compactors. It includes both gears, pin spring, C-ring, ram stop, and ram cam.

$1.95

Foot, Front - Single

Sold Individually.

$5.54

Touch-Up Paint - White

$9.06

Charcoal Filter

Sold individually.

$46.03

Rotary Switch Kit

This kit comes an on-off rotary switch, and two chrome knobs.

$49.80

15" White Plastic Compactor Bags - 60 Pack

$62.87

Container Handle

$29.75

Directional Switch

$23.71

Switch Knob

Also known as a rotary switch knob.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Compactor stuck in lower position

  • Customer: Asbjorn from The Woodlands TX
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Wrench(Adjustable)
  • 20 of 22 people found this instruction helpful
Moved the compactor out from under cabinet and unplugged the powercable.Laid compactor over on its side Removed the top (4 screws) and base plate (3 screws) as well as the coverplate for the motor(3 screws)Found that large drive was broken in half. Used two screwdrivers to start split ring then pliers to pull it off the rest of the way.
Removed the driv... read more

Trash Compactor ram wouldn't lower

  • Customer: Scott from Indianapolis IN
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 14 of 15 people found this instruction helpful
I pulled the trash compactor out from under the counter.

I took out the four screws that kept the top cover in place to expose the ram.

The gear shafts were turning but the ram would not lower, at first I though the ram drive bolts were stripped and it wouldn't engage the shaft. Then I realized there was a mechanical directional\limit s... read more

Compactor motor kept running after cycle ran, making alot of noise and unit jumping around.

  • Customer: Keith from Keller TX
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 13 of 14 people found this instruction helpful
Pulled the Compactor from underneath cabinet, unplugged power. Removed the top plate off compactor to expose the crush piston. Removed the front control panel by removing two phillips screws, wiring and directional (limit) switch is now exposed. Removed the two screws securing switch, removed wiring one wire at a time and replaced on new switch in same posit... read more