Quick Question!

Have you ever purchased from PartSelect.com before?

Models > KSRP25FNSS00 > Parts

KSRP25FNSS00 KitchenAid Refrigerator - Parts

All parts for the KitchenAid Refrigerator KSRP25FNSS00

Below is a list of all parts for the KitchenAid Refrigerator KSRP25FNSS00. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the KSRP25FNSS00
1-14 of 346
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$3.88

Light Bulb - 40W

This an authentic OEM 40-Watt replacement light bulb, used in a number of household appliances. It is specially designed to withstand extreme temperatures, which is why these repla...

$5.48

Lower Door Closing Cam

The lower door closing cam is designed for use with refrigerators. It can be used on either the fresh food side, or the freezer side. It helps raise the door into position so the door can seal properly when closed. It also allows the door to easily swing open and closed. This cam is made out of plastic, so it might crack or wear down over time. If your door will not open and close properly you may need to replace a door closing cam. To successfully install this part, you will need a 5/16 nut driver and a small flat blade screwdriver. Before you begin, unplug your appliance and disconnect the water supply. This replacement part is sold individually.

$70.75

Water Inlet Valve

Note: This valve has been updated by the manufacturer and NO longer includes the removable pre-filter bracket connector. Must be ordered separately part number WPW10445062.

$70.52

Water Filter

This ice and water filter fits all Whirlpool and KitchenAid refrigerators with a water filter located in the base grill, below the refrigerator door. This part will also fit any Kenmore models starting with 106. This filter is NSF certified, and is meant to filter for taste and odor, sediment, chlorine, and lead. The filtering provides overall better tasting and higher quality water. For best results, it is recommended to change your ice and water filter every six months or 200 gallons of filtered water. For better filtering, try the PS373105 filter. There are no tools required for this repair.

$4.75

Door Cam - Black

The lower door cam is also known as the closing cam or door closer cam and can be found on your refrigerator or freezer door. The purpose of the lower door cam is to lift the door ...

$8.84

Ice Guide

This is a refrigerator ice guide that is made entirely of clear plastic. This ice guide is located in the freezer door. Turn your refrigerator ice dispenser off before replacing the part. This is a simple repair, and the only tool you will need is a small flat blade screwdriver to push on the pivot tab on the bottom of the ice guide. Do not worry about breaking side or pivot tabs on your existing ice guide because it will be discarded anyway. This is a genuine manufacturer replacement part.

$124.31

Ice Maker Assembly - 8 Cube

This icemaker can be used with 25-27 cubic feet refrigerators that have a vertical auger dispenser located on the freezer door. Reuse bottom bracket from the original icemaker and...

$23.78

Bi-Metal Defrost Thermostat

If you have ice building up in your freezer, or if your freezer is getting too warm during the defrost cycle you may need to replace the bi-metal defrost thermostat. The function of the defrost bi-metal thermostat is to clip onto the evaporator and protect your evaporator from overheating during the defrost cycle. If your refrigerator does not defrost properly you can test both the thermostat and the heater to figure out which part is at fault. For this repair, you will need a Phillips screwdriver, a 1/4 inch nut driver, a flat blade screwdriver, a pair of wire strippers, a roll of electrical tape, and a few butt splice connectors.

$65.25

Icemaker Control Assembly

The icemaker control assembly is located in the freezer section of your refrigerator. It is what controls the icemaker. The control turns the timing cams and the ejector blades. It...

$25.55

Grille, Overflow (Black)

This grille is located on the bottom of the ice/water dispenser to catch the overflow.

$55.13

Ice Door Kit

In this kit you will find the support, the ice door, spring, and delay. The heater ribbon is no longer needed and therefore will not be included with this part. This kit works in t...

$87.13

Condenser Fan Motor Kit

This condenser fan motor kit includes a motor, fan blade, wire harness, and screws. Used in a refrigerator, the condenser fan motor moves the condenser fan blade to direct and move air across the condenser coil. Please note: The manufacturer has changed the appearance of the product from the original. The kit still functions the same as the original part. It is an OEM factory replacement. Make sure to unplug the refrigerator from the power source and wear gloves to protect your hands. Also, a helpful tip is to store food to prevent deterioration when the power is off.

$3.02

Screw

This screw is sold individually.

$47.35

Capacitor

This capacitor is also known as a run capacitor, and it is most often used in refrigerators and freezers. This part provides the voltage or energy current required to start the compressor and keep it running. It allows the compressor in your appliance to easily cycle on and off. Doing so enables the appliance to effortlessly maintain its internal temperature. If the capacitor is faulty your refrigerator or freezer might be too warm, or you may notice the compressor will hum, but it will not run. When replacing your capacitor, you should check the old one for any signs of damage, overheating, or arcing, as that may suggest there is a bigger problem with your appliance.

All Parts for the KSRP25FNSS00
1-14 of 346