Models > KGCU462VSS00

KGCU462VSS00 KitchenAid Cooktop - Overview

Get Parts and Repair Help for KGCU462VSS00

If you know the cooktop repair part you need, you can browse the list of all parts on the KGCU462VSS00, or you can search by name or part description. You can also find your part by where it is located on the KGCU462VSS00 by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.70

Screw

This screw is sold individually.

$7.87

Grate Pads - Set of 4

$4.60

Lid Hinge Mounting Screw

Sold individually.

$8.12

USE MCN TJ128

$31.15

Burner Cap - Left Rear - Black

Sold individually.

$99.05

REGULATOR

$41.50

CNVRSN-KIT

$30.87

CAP-BURNER

$181.27

Wave Plate

$161.13

SPARK MODULE 0+4 REIGNIT

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Burners kept clicking after ignited

  • Customer: Robert from Ranchos de Taos NM
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 9 of 9 people found this instruction helpful
This problem was driving me crazy for months. Of course, after I bought and installed the part and it still was not fixed I finally found a website that told me how to fix the clicking. The problem is that the removable head burners (#8 on the top assembly diagram) are not making good electrical contact with the base burners (#22). What I did was grab the he... read more

One burner would continually keep sparking after burner ignited

  • Customer: Michael from St Louis MO
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 2 of 3 people found this instruction helpful
Removed the small access cover on the bottom of the cooktop by reaching inside and under the cabinets. Removed the module which was held by two hex head screws, unplugged the wires noting the location and color of the wires. Plugged the wires into the new module in the proper locations as noted previously. Attached the module with two screws, and then attach... read more

the spark igniters would continue to spark after the burners were lit

  • Customer: Robert from White Rock NM
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 1 of 3 people found this instruction helpful
Since the problem would only occur when the right front burner was on, I first replaced the ignitor, but the problem persisted. To replace the spark module I had to pull the range out of the nook it is in in the counter top. Then (after ensuring that the power was off) I removed the back cover. The spark module was easily located and removing two screws and... read more