KGCT365TBL1 KitchenAid Cooktop - Instructions

Turned off the gas then disconnected the gas line. Unplugged the AC cord and removed the unit from the counter top. Had to locate a suitable area to lay the cooktop, rather large. The bottom cover is held on by 6-8 sheet metal screws, however, the gas regulator and nipple must be removed also for the cover to come off. I removed the Igniter module screws, leaving the wires connected and mounted the new module in it's place. I then removed one wire at a time from the old and put it on the new part. Replaced the back cover and reinstalled the gas regulator with fresh pipe sealant. Probably took an hour including cleaning the top and counter top.

the knobs where hard to find around my area. i went to several appliance repair stores and they were unable to locate the knobs. so, i went online, your site made finding them easy because i was able to restrict my search to exactly what i needed. they shipped quickly, we are very pleased.

Removed broken control knob - and replaced with new one

Bought in auto repair store special black glue used for sealing gaskets. Husband needed to use latex gloves, toothpicks, ice pick, and small screw driver to glue and install new burner pads.

I removed the old knobs & replaced with new knobs.

The repair was fairly straightforward, much easier the second time around. The first part was defective. (irregular spark). I reordered and installed the new one. It works, but nowhere near as good as the original.The problem is that the frequency of the spark on these replacement modules is only once per second. To get technical, the gas as presented to the spark is turbulent, causing several sparks to occur before the ideal mixture coincides with the spark. Needless to say, there is an excess of gas wafting around the kitchen until it lights, sometimes in excess of 20 seconds. NOT SAFE! Our BBQ and fireplace insert spark orders of magnitude faster than this.

Centered over the existing post and pushed down...very simple

My folks were swtitching one knob around to controll all the burners. The repairman said the cooktop had been long retired and the only option was buying a new one. It's a great cooktop, though and it was a shame to ditch it for just because of knobs. Alas, right before we about to buy a new one, I discovered you guys. Halleluiah.

Remobe broken knob and replace

Replaced them easily by putting these new knobs on. Easy peasy lemon sqeazy.

just removed old knob,and installed new one.a no brainer!

pushed new knobs onto shafts

Replaced broken knobs with new ones and the problem was solved.

just removed the old cracked knobs and place the new ones

They are slip-fit onto burner controls. Pulled them up, aligned new "D" shape in know with control, gently pushed them straight down. Careful, they apparently crack easily.