The knob skirt or grommet on your range goes around the knob, forming a buffer between it and the range surface. If your knob skirt is damaged, you should consider replacing it. This product is approx...
This white knob skirt is located between the glass top and the control knobs of your stove top. The skirt has an outside diameter of approximately 2 inches. The most common reasons to replace the time...
This part is a black plastic knob that is most often used as a burner control knob. This knob allows you to turn the burner on your range or cooktop on, and it allows you to control the temperature of...
This is a switch that creates the spark that lights the gas and starts the burners.
When the gas burner valve knob is depressed and turned, this part creates a spark that lights the gas and starts the burner.
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
David
August 23, 2021
All 4 igniters still spark even after all 4 units are burning, caps are positioned correctly.
For model number KGCT305BBL4
Hi David,
Thank you for your question. If the burners have any moisture in them, they will continue to click until they have completely dried out. If you have just recently cleaned the stovetop or if a pot of water has boiled over, this may account for the clicking/sparking you are experiencing. If moisture is not the issue, check the burners to see if they have food debris on them that may be preventing them from working correctly. If they do have food debris on them, use a metal pin or paper clip to remove the debris and then soak them in warm soapy water. Rinse them and let them dry out completely before using them again. If the clicking persists, you will need to check the spark module, the igniter switches and the spark electrodes. We hope this helps! If you have any questions, please let us know.
Hello David, Thank you for the question. One of the most common reasons a gas stove keeps clicking, even after it's lit, is that the burner cap is out of alignment. We hope this helps!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
The only real issue was locating the proper adhesive to ensure that the new pads would not fall out. The small insert paper slip in the package noted that a RTV adhesive should be used. After much searching at the home improvement super store, I learned it would be found at an auto supply store. It is black, and is for high temp use. It i
... Read mores available in a small tube for around $2.00. The RTV is usually used to make gaskets for heat/oil exposure in auto repair. I did have trouble removing a broken stub from a pad that had broken off in the hole. I used an awl to get what I could and push the rest into the hole deeper, then insert a new pad with along with the adhesive.
Turned off the gas then disconnected the gas line. Unplugged the AC cord and removed the unit from the counter top. Had to locate a suitable area to lay the cooktop, rather large. The bottom cover is held on by 6-8 sheet metal screws, however, the gas regulator and nipple must be removed also for the cover to come off. I removed the Ignit
... Read moreer module screws, leaving the wires connected and mounted the new module in it's place. I then removed one wire at a time from the old and put it on the new part. Replaced the back cover and reinstalled the gas regulator with fresh pipe sealant. Probably took an hour including cleaning the top and counter top.
I used a screwdriver to pry the electrode assy. out of the burner. then disconnected the wire. Then just connected the new electrode and place the assy, in the burner.