Models > KGCC766RSS01

KGCC766RSS01 KitchenAid Cooktop - Overview

Get Parts and Repair Help for KGCC766RSS01

If you know the cooktop repair part you need, you can browse the list of all parts on the KGCC766RSS01, or you can search by name or part description. You can also find your part by where it is located on the KGCC766RSS01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.70

Torx Screw

7-18 x 3/4" - sold individually.

$5.74

SCREW

Sold individually.

$17.42

Burner Knob

Sold individually. This knob accepts a D-shaped shaft.

$38.88

Natural Gas To Liquid Propane Gas Conversion Kit

$13.48

Surface Igniter

Also known as Spark Electrode. This part helps your burner ignite and produce flame.

$4.70

Screw

Sold individually.

$57.64

Igniter Switches with Harness

This part includes 5 ignition switches and the wire harness. You can not purchase these separately.

$106.50

Double Burner Grate - Black

$31.37

Burner Head - 16K

This part distributes flame evenly to your cookware.

$21.86

Burner Head - 6K

This is the Right Rear Burner Head.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Igniter problem on one gas burner

  • Customer: Roland from Houston TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 10 of 10 people found this instruction helpful
I had to remove the two separate components of the gas burner unit, each had two screws. I lifted then tilted the lower portion of the burner unit to allow access to the underside of the igniter. I removed the wire and then with an offset screwdriver I removed the single screw that held the igniter in place. I reversed the steps to install the replacement,... read more

I had a faulty wiring on the igniter switches.

  • Customer: Raymundo from Cerritos CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 9 of 11 people found this instruction helpful
replaced the set of igniter switches I order from Partselect .com. read more

Replace Gas Cooktop bad surface Igniter

  • Customer: Charles from Williamsburg VA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 2 of 3 people found this instruction helpful
1. Turn off Gas at valve under cooktop. Unplug electric to igniters. 2. Remove all control knobs. 3. Remove grates and burner covers. 4. Remove screws from each burner head (10 screws) 5. lift and remove cooktop cover. 6. Reach under cabinet and push up main cooktop body (about 4 or 5 inches) and BLOCK. 7. AT FRONT OF COOKTOP REMOVE 2 philips screws holdi... read more