Models > KGCC506RBL04

KGCC506RBL04 KitchenAid Cooktop - Overview

Get Parts and Repair Help for KGCC506RBL04

If you know the cooktop repair part you need, you can browse the list of all parts on the KGCC506RBL04, or you can search by name or part description. You can also find your part by where it is located on the KGCC506RBL04 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.70

Torx Screw

7-18 x 3/4" - sold individually.

$4.21

Glass Top Knob Skirt

$3.76

Knob Skirt

$2.70

Igniter Screw

This screw is sold individually.

$13.61

Burner Knob

Sold individually. This knob accepts a D-shaped shaft.

$17.92

Surface Igniter

Also known as Spark Electrode. This part helps your burner ignite and produce flame.

$32.03

Burner Cap - Left Rear/Right Front - Coal Matte Black

$88.46

Spark Module

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

$38.12

Natural Gas To Liquid Propane Gas Conversion Kit

$48.51

Burner Cap - Right Rear - Coal Matte Black

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Top burners would not light. No "clicking" .

  • Customer: Carolyn from Bellingham MA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 10 of 12 people found this instruction helpful
My husband and I replaced the igniter module, following directions we found online. We removed the old one, replaced it with the new one, and thankfully everything is working great! read more

Igniter problem on one gas burner

  • Customer: Roland from Houston TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 8 of 8 people found this instruction helpful
I had to remove the two separate components of the gas burner unit, each had two screws. I lifted then tilted the lower portion of the burner unit to allow access to the underside of the igniter. I removed the wire and then with an offset screwdriver I removed the single screw that held the igniter in place. I reversed the steps to install the replacement,... read more

igniter short circut

  • Customer: Jim from Grove City OH
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 8 of 16 people found this instruction helpful
Replace igniters read more