Models > KFIS20XVMS00

KFIS20XVMS00 KitchenAid Refrigerator - Overview

Get Parts and Repair Help for KFIS20XVMS00

If you know the refrigerator repair part you need, you can browse the list of all parts on the KFIS20XVMS00, or you can search by name or part description. You can also find your part by where it is located on the KFIS20XVMS00 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for KFIS20XVMS00 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Light Bulb - 40W

Sold individually.


Pantry End Cap - Left Side

Sold individually.



This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.


Pantry End Cap - Right Side

This part mounts on the wall and is used to support the pantry drawer.


Pantry Drawer Lid

This part helps keep everything inside the drawer, it acts as a cover and also keeps you drawer at the proper temperature by creating a seal.



This screw is sold individually.


Water Filter Bypass Cap

This cap is used when bypassing the filter.


Kickplate Grille - Apollo Grey

This kickplate grille is attached to the bottom of the refrigerator.


Light Switch

This part turns on the light when the door is opened.


Handle Mount

Sold Individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

light on to order water filter

  • Customer: Douglas from Byron NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 573 of 604 people found this instruction helpful
Pressed in the end of the filter cover, lowered it down part way. Twisted the old filter 1/4 turn and removed it. Set in the sink to drain. Inserted new filter and twisted it to lock. closed cover. Done. Total time @ 1 Minute. read more

Removing the existing filter by rotating as directed and then dislodging from 'docking' station proved difficult. Turns out, the old filter is under a bit of vacuum pressure and getting the unit to separate or release was a challenge.

  • Customer: Jake from Novato CA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 189 of 279 people found this instruction helpful
I removed the drop-down outer housing by gently prying the sides of the two pivot pins at the rear. This gave me move 'room' to grip and slightly rotate then pull the old filter forward and away from the tight suction connection. I was concerned that I would be too forceful for the plastic assemblies and would break something; deliberate motions and a steady... read more

My refrigerator stopped cooling and the freezer section stopped freezing

  • Customer: garth from forest lake MN
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 135 of 148 people found this instruction helpful
I knew the chances of all the freon leaking out was unlikely so I looked at the wiring to the compressor and there was a capacitor and a starter/overload so i figured I would start there. I went on line and found the parts at this site and they were less than the minimum service call charge for a service tech so I figured what the heck let's give her a shot ... read more